User's Guide

Quick Set-Up Guide

Time Sensitive Step

Repeat Steps 1 and 2 to link additional Smart Appliances.

Check to ensure your Smart Appliance and Wireless Router are properly installed and powered on; an Internet connection is required.

Note: Only one Smart Appliance can be linked at a time.

To Start...

Internet

Go Online to Set up your User Account and add

your Smart Appliances at http://smart.whirlpool.com

Note: Be sure to have your Smart Appliance’s 10-digit

Smart ID#, as you will be prompted to enter them into

your User Account.

My Smart Appliance ID # Is:______________________________________________

Press the Smart Grid Button on the Appliance Within 2 Minutes of Step 1

Note: The Smart Grid indicator light will blink while the Wireless Router and

appliance communicate. This may take up to 2 minutes. When the Smart

Grid and WPS LED indicators remain lit, the linking process is complete.

Any wireless router with WPS technology will function with Whirlpool

Smart Appliances, however, Whirlpool recommends the use of the

Cisco Linksys E4200 or the Netgear WNR3500LV2.

For more information, go to http:// smart.whirlpool.com

Internet

Wireless Router

INTERNET

USBUSB

RESETRESET

POWERPOWER

ETHERNET

Actual Smart Grid

indicator may vary.

Actual Smart Grid

indicator may vary.

Step 3 :Step 2 :Step 1 :

Smart Grid Appliances

Press the WPS (Wi Protected Setup) button on the Wireless Router

Note: The WPS LED will begin blinking. Complete Step 2 within 2 minutes

after completing Step 1.

INTERNET

USBUSB

RESETRESET

POWERPOWER

ETHERNET

PAGE 1
To Start... Check to ensure your Smart Appliance and Wireless Router are properly installed and powered on; an Internet connection is required. Note: Only one Smart Appliance can be linked at a time. Smart Grid Appliances Quick Set-Up Guide Any wireless router with WPS technology will function with Whirlpool Smart Appliances, however, Whirlpool recommends the use of the Cisco Linksys E4200 or the Netgear WNR3500LV2.
PAGE 2
Problem Solver Once you have linked your appliance(s) with your Wireless Router, they will remain linked, even in the event of a power outage, moving, or extended storage. If you replace the Wireless Router, you will need to complete the linking process again. Problem Smart Grid indicator is blinking. Below are solutions to common problems when connecting your new Smart Appliance to your wireless network.