Installation guide

Three-wire connection...
Page 1O
Three-wire receptacle
4. Loosen or remove center
terminal block screw,
5. Connect the neutral wire
or center) of power supply cord to
the center, silver-colored terminal
screw of the terminal block,
Tighten screw,
6. Connect the other wires to
outer terminal block screws,
Tighten screws,
7. Tighten strain relief screws, _.
8. Reinstall terminal block cover to _ _ \_ _
the dryer rear panel, Secure cover
with hold-down screw,
Where local codes permit
connecting cabinet-ground conductor to neutral wire:
4. Loosen or remove
terminal block screw.
5. Place the hooked end of the
neutral wire (white or center) of
power supply cable under the center
screw of the terminal block (hook
facing right). Squeeze hooked end
together. Tighten screw.
6. Place the hooked ends of the
other power supply cable wires
under the outer terminal block
screws (hook facing right). Squeeze
hooked ends together. Tighten
screws.
7. Tighten strain relief screws.
8. Reinstall terminal block cover to
the dryer rear panel. Secure cover
with hold-down screw.