Installation guide

ManualsBrandsWhirlpool ManualsDryerOfficial Whirlpool dryer

Table of Contents

_ Introduction

Pages 2 - 4

Requirements

Page4- 6

_ Installation steps

Pages 6 - 8

Table des mati_res

I Introduction

Pages 2 _. 4

Exigences

Pages 4 _. 6

Etapes d'installation

Pages 6 _t 8

Important:

• Installer: LeaveInstallation Instructions with the

homeown_.

• Homeowner:. KeepInstallation Instructions for future

reference.

• For best performance, install dryeraccording to

Installation Instructions. Failure to complete installation as

instructed could void warranty.

• Save Installation Instructions for local electrical inspector's

llSe.

Important :

• lnstallateur : Remett_eles instructionsd'installatienall

propri_taJre.

• ProFri_taire : Conserverles instructionsd'installationpour

consultationullArieure.

• Pour obtenir la meflleure performance, installerla

s_cheuse conform(anentanx instructionsd'installation.La

garantiedu produit pourraitne pas _0"ehonor_e si

l'installationn'est pas ex(_ut_econformSnent auxinstructions.

• Conserver les instructionsd'installationpour consultationpar

l'inspecteurlocaldes installationseqectdques.

PartNo. 3397620 Rev.A

Piece N° 3397620 R@.A

Summary of content (10 pages)

PAGE 1
Table des mati_res Table of Contents Pages 2 - 4 _ Introduction Requirements Page4- _ 6 Installation steps Pages 6 - 8 Important: • Installer: LeaveInstallation Instructions with the homeown_. • Homeowner:. reference. Keep Installation Instructions for future • For best performance, install dryer according to Installation Instructions. Failure to complete installation as instructed could void warranty. • Save Installation Instructions for local electrical inspector's llSe. Part No. 3397620 Rev.
PAGE 2
0 Ol 0 0 Ol 0 Your safety and the safety others is very important. Votre of We have provided many important safety message in this manual and on your appliance. Always read and obey all safety messages. This is the safety symbol.that This symbol alerts youalert to hazards can kill or hurt you and others. All safety messages will be preceded by the safety alert symbol and the word =DANGER" or =WARNING". These words mean: s_curit_ et celle des autres sont tr_s importantes.
PAGE 3
7.6 7,6 m (3 po) m (31_ ( 1411 ) m,_l, 35,6cm closet door (14 po) max. portede placard © 7.6 cm • If codes permit, dryer may be installed in a recessed area or closet using dimensions shown. • Dimensions are in centimeters end inches and are the minimum allowable. (]I_ 7,6 m (3 po) **Minimum top and bottom air openings for closet door. ***External exhaust elbow requires additional s_i ** Surface minimum des ouvertures de passage d'air en haut et eu has, pour porte de placard.
PAGE 4
_eck local codes and see electrical and venting requirements, Pages 4 - 6, before purchasing parts. Avantl'achat de ccs articles, consulter les codes en viguenr et _tudier auxpages 4 _.6 les sp6cifications de l'installafion 61ectrique et de raccordement _ l'ext_rienr. Electrical Installation This dryer is equipped with a 1.5 m (5 Foot), CSA-certifiedpower supply cord. Cette s_chense est monie d'on c_le d'alimentation de 1,5 m (5 pi), homologn6 par I'ACNOR.
PAGE 5
Exhaust requirements, cont. Do Notuse plastic or metal foil vent. Flexible metal vent must be fully extended and supported when the dryer is in its final position. Remove excess flexible vent to avoid sagging and kinking that may result in reduced air flow• An exhaust hood (A) should cap the exhaust vent to prevent exhausted air from returning m the dryer. Exhaust outlet hood must be at least 30.
PAGE 6
Puton safetyglasses end gloves. Porterdes gentset des lunettesde s_u'it_. Installexhausthood (A). Use caafking compound to seal exterior wall openingaround exhausthood. Installer le dapet de d6charge(A). Calfcutrerl'ouvertore murale _.l'ext6ricur autour du clapet de d6charge. Run exhaustventto dryerlocation. Usethe straightestpath possible.Avoid90° turns.Useclamps to seal all joints. Acheminerle conduit d'dvacuationjusqu'itl'emplacomentde la s_cheuse,utiliser l'itin6rairele plus rectilignepossible.
PAGE 7
AvailableonSuper-widefide-swingand Largeside-swingdoor models only. Ifnot reversingdoor swing,skip aheadto "Leveland exhaust dryer"steps. Be careful not to scratch or chip Ire'rot. Placea largetowd or soft cloth (A) on top of dryer. Opendryerdoor.Removebottom screwsfromcabinet side of hinges(B). Loosen(do not remove)topscrewsfrom cabinet side ofhinges. Liftdoor until top screwsin cabinet are in largepart ofhinge slot. Pulldoor forwardoffscrews.Set door (handle side up) on topof dryer.
PAGE 8
Dryer must be level to reduce noise and assure proper performance. slide dryer onto cardboard or hardboard before moving across floor to prevent floor damage. Movedryercloseto its permanent location.Leaveenough roomto connect exhaustvent.Removecardboard orhardboard from under dryer. sideto side,then frnnt to back. If dryeris not level,adjust dryer gaeck levelnessof legsup ordown. dryerby placinga levelon top of dryer,first Iflegs are not long enough tolevel dryer,orderExtendedDryer FeetKit,Pm-tNo.
PAGE 9
Kits Make Installation Easy • Provides4 1/2" clearancebetween dryerandwall • Snap-Lockfittings • Total kit length 8 feet • Additional vent can be snapped between sections for longer runs Part#4396028 Kit Contains: 2- 4' vent sectionswith attachedclose elbows 1- Wall plate for closeclearance installations 2- 4" clamps For more information, or to have your venting professionally installed, call the Consumer Assistance Center.
PAGE 10
Callyour dealeror local authorized servicecompany. When you call, you will need the dryer model number and serial number. Both numbers are on the model/serial rating plate located in the door well behind the dryer door and on front of opening. Record the numbers here for handy reference: Contacter votte concessionnaire ou on _tabhssement de service agr_ local. Lors de cette prise de contact, on vous demandera le num_ro de module ct le num_ro de s_rie de rapparefl.