Installation guide

VentingRequirements PlanVentSystem
Fire Hazard
Use a heavy metal vent.
Do not use a plaatlc vent.
Do not use a metal foil vent.
Failure to follow these Inatructlone can result In death
or fire.
WARNING: To reduce the risk of fire, this dryer MUST BE
EXHAUSTED OUTDOORS.
4 in. (10.2 cm) heavy metal exhaust vent and clamps must be
used. DURASAFE TM venting products are recommended.
DURASAFE TM vent products can be purchased from your dealer
or by calling Whirlpool Parts and Accessories. For more
information, see the "Assistance or Service" section of your
"Dryer User Instructions."
• Do not exhaust the dryer into any gas vent, chimney, wall,
ceiling, or a concealed space of a building.
• Do not use an exhaust hood with a magnetic latch.
• Do not installflexible metal vent in enclosed walls, ceilings or
floors.
• Do not use screws or ether fastening devices that extend into
the interiorof the vent to secure vent.
IMPORTANT: Observe all governing codas and ordinances.
Improper venting can cause moisture and lint to collect
Indoors, which may result In:
• Moisture damage to woodwork, furniture, paint, wall-
paper, carpets, etc.
• Housecleaning problems and health problems.
Use a heavy metal vent. Do net use plastic or metal foil vent.
Rigid metal vent isrecommended to prevent crushing and kinking.
Flexible metal vent must be fullyextended and supported when
the dryer is in its final position. Remove excess flexible metal vent
to avoid sagging and kinking that may result in reduced airflow
and poor performance.
An exhaust hood should cap the vent to prevent rodents and
insects from entering the home.
Exhaust hood must be at least 12 in. (30.5 cm) from the ground or
any object that may be inthe path of the exhaust (such as flowers,
rocks or bushes, etc.).
If using an existing vent system, clean lintfrom the entire length of
the system and make sure exhaust hood is not plugged with lint.
Replace any plastic or metal foil vent with rigid metal or flexible
metal vent.
Use clamps to seal all joints. Do not use duct tape, screws or
ether fastening devices that extend into the interior of the vent to
eacure vent.
Typical exhaust installations
Typicalinstallationsventthe dryerfromtherearofthe dryer,
1 m
2
1. Dryer
2. Elbow
3. Wail
4. Exhaust hood
5. Clamps
6. Rigid metal or flexible metal vent
7, Vent length necessary to connect elbows
8, Exhaust outlet
Standard exhaust installation with rigid metal or flexible
metal vent
Altemate installations for close clearances
Venting systems come in many varieties. Select the type best for
your installation. Two close-clearance installations are shown.
Refer to the manufacturer's instructions.
1 2
1. Over- The- Top installation (also available with one
offset elbow)
2. Periscope installation
NOTE: The following kits for close clearance alternate installations
are available for purchase. Please see the service numbers
located in your "Dryer User Instructions."
• Over-The-Top Installation:
Part Number 4396028
4