Installation guide

ManualsBrandsWhirlpool Manualswall ovenOfficial Whirlpool electric built-in oven

Quick Reference

Table of Contents:

Pages

[] Product dimensions

[] Cutout dimensions

[] Before you start

[] Electrical requirements

[] [] Installation steps

if you need assistance:

Check your Use and Care Guide for a toll-free number

to call or call the dealer from whom you purchased

this appliance. The dealer is listed in the Yellow Pages

of your phone directory under "Appliances-

Household -- Major -- Service and Repair."

Call when you:

[] Nave questions about built-in oven installation or

operation.

[] Need to obtain the name and number of an

authorized service company.

When you call, you will need:

[] The built-in oven model number.

[] The built-in oven serial number.

Both numbers are listed on the model/serial rating

plate, located on the oven door or on the oven frame.

Summary of content (10 pages)

PAGE 1
Quick Reference Table of Contents: Pages [] [] Product dimensions [] Cutout dimensions [] Before you start [] Electrical requirements [] Installation steps if you need assistance: Check your Use and Care Guide for a toll-free number to call or call the dealer from whom you purchased this appliance. The dealer is listed in the Yellow Pages of your phone directory under "AppliancesHousehold -- Major -- Service and Repair.
PAGE 2
Single oven Double oven important: Observe all governing codes and ordinances. 28-3/8" Proper installation is your responsibility. Have a qualified technician install this oven. 28-3/8" (72.1 cm} max. recessed width Oven location should be away from strong draft areas, such as windows, doors and strong heating vents. Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance. 29"' 27-1/2" (89.9 cm) recessed height (73.7 cm) max, overall 51" (129.
PAGE 3
Do Not have a fuse in the neutral or grounding circuit. Oven must be connected to the proper electrical voltage and frequency as specified on the model/serial rating plate. (The model/serial rating plate is located on the oven door or on the oven frame.) [] Models rated from 7,3 to 9,6 kW at 240 volts (5.5 to 7.2 kW at 208 volts) require a separate 40-ampere circuit. Models rated at 7.2 kW and below at 240 volts (5.4 kW and below at 208 volts) require a separate 30-ampere circuit. Electrically ground oven.
PAGE 4
Electricalconnection cable from power supply cable from power supply junction box _ junction box black reel __ white 'es wire W_ Electrical Shock Hazard Disconnect power to the junction box before making connection. Electrically ground oven. Connect ground with lO-gauge-minimum solid copper wire. Failure to follow these instructions could result in death, fire or electrical shock.
PAGE 5
if oven does not if you need service: operate: Maintain the quality built into your built-in oven by calling an authorized service company. To obtain the name and number of an authorized service company: [] Check that circuit breaker is not tripped or house fuse blown. [] See Use and Care Guide for troubleshooting list. if you need assistance: if you have questions about operating, cleaning or maintaining your oven: [] Refer to Use and Care Guide.
PAGE 6
Reference rapide Table des matibres : Pages [_ Dimensions des produits [_ Dimensions de d@oupage [_ Avant de commencer 121Alimentation [] [] electrique Etapes de I'installation Si une assistance Trouvez est necessaire... dans le Guide d'utilisation et d'entretien le numero composer (sans frais), ou contactez le concessionnaire chez qui cet appareil a ete achete.
PAGE 7
Fours jumel6s Four simple Important : Respecter les prescriptions de tous les codes et reglements en vigueur. C'est au proprietaire qu'incombe la responsabilite d'une installation correcte. Demander aun technicien qualifie d'effectuer I'installation de ce four. Largeur maximum d'encastrement Largeur maximum d'encastrement - - I .......
PAGE 8
Risque de choc _leotrique Relier _lectriquement le four _ la torte. Relier le four _ la terre _ I'aide d'un cenduoteur de cuivre, calibre 10 minimum, Le non-respect de ces instructions peut _tre la cause de choc _leotrique, d'incendie ou d'aooident mortel.
PAGE 9
Raccordement au circuit electrique c_bleducircuitd'alimentation boite de _ connexion frilos L _ _ _ fils _ --'-'_' -,f,a.oira Risque de choc _lectrique fil nu de liaison a la Avant d'ex_cuter lea raccordements, interrompre I'alimentation _lectrique au niveau de la boite de distribution. Relier _lectriquement le four _ la terre. Relier le four _ la terre _ I'aide d'un conducteur de cuivre, calibre 10 minimum.
PAGE 10
Si le four ne fonctionne pas... [] Determiner sile disjoncteur fusible est grille. est ouvert [] Consulter la section Diagnostic d'utilisation et d'entretien. Si une intervention d'entretien ou sile dans le Guide m Pour route question au sujet de I'utilisation, nettoyage ou de I'entretien du four : Consulter le Guide d'utilisation du et d'entretien.