Installation guide

ManualsBrandsWhirlpool ManualsRangeOfficial Whirlpool gas freestanding range

Quick Reference

Table of Contents:

Pages

[]

I_1-%

%-%

[]

Before you start

Product dimensions

Cutout dimensions/requirements

Electrical requirements

Gas supply requirements

Installation steps

Gas conversions

Moving the range

If range does not operate

If you need assistance/service

Tip Over Hazard

A child or adult can tip the range and

be killed,

Connect anti-tip bracket to rear range

foot.

Reconnect the anti-tip bracket, ifthe

range is moved,

Failure to follow these instructions

can result in death or serious burns

to children and adults.

IMPORTANT:

Beadand savethese

instrnctiens,

iMPORTANT:

Installer: Leave installation

instructions with the homeowner.

Homeowner: Keep Installation

instructions for future reference.

Save Installation instructions for local

electrical inspector's use.

www.whirlpool.com

Write down the model and serial numbers

before installing range.

Both numbers are on the model/seriaa

rating plate, located on the oven frame

behind the left side of the broiler door.

Model #

Serial #

PartNo. 98014108

Summary of content (11 pages)

PAGE 1
Quick Reference Table of Contents: Pages [] Before you start [] Product dimensions [] Cutout dimensions/requirements [] Electrical requirements I_1-% Gas supply requirements Installation steps %-% [] [] [] Gas conversions Moving the range If range does not operate If you need assistance/service www.whirlpool.com IMPORTANT: Beadand save these instrnctiens, Tip Over Hazard A child or adult can tip the range and be killed, Connect anti-tip bracket to rear range foot.
PAGE 2
Before you start... liquids in the vicinity of this or any other appliance. mWHATTO DO IFYOU SMELL GAS * Do not try to light any appliance. * Do not touch any electrical switch. * Do not use any phone in your building. * Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. * If you cannot reach your gas supplier, call the fire department. Installation and service must be performed by a qualified installer, service agency or the gas supplier.
PAGE 3
Product dimensions Parts supplied for installation: anti-tip bracket Hot shown: ,, literature pack ,, orifice spuds 26-3/4" (07.9 cm) depth witf handle 2 screws(#10x 1-1/2") _2 30 plasticanchors (Bracket must be securely mounted to sub-floor. Thickness of flooring may require longer screws to anchor the bracket to sub-floor.) 46-1/4" (117.5cm) overall height for tail backguard models Grounded electrical outlet is required. See "Electrical requirements" Page 4.
PAGE 4
ElectricaJ requirements EJectrical Shock Hazard Plug into a grounded outlet. 3-prong Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. Do Not ground to a gas pipe. Check with a qualified electrician if you are not sure range is properly grounded.
PAGE 5
WithL.Rgas,pipingortubingsizecanbe 1/2"minimum.Asmallersizepipeon longerrunsmayresultin insufficient gas supply.Usually, L.Rgassuppliers determine thesizeandmaterials usedin thesystem. Pipe-joint compounds madefor usewith L.Rgasmustbeusedonpipethreads only. Flexible metal appliance connector: If local codes permit, a new CSA designcertified, 1/2" or 3/4" I.D., flexible metal appliance connector is recommended for connecting range to the gas supply line.
PAGE 6
All connections must be wrench-tightened. anti-tip\ / bracket 90°elbow __ _J range foot ., Making sure the anti-tip bracket is installed: • Look for the anti-tip bracket securely attached to floor. • Slide range back so rear range foot is under anti-tip bracket. pressure regulator _ connection fitting U union-- Typicalrigid pipe connection pipe _ .
PAGE 7
Check operation of cooktop [] Replace control panel and tighten screws securely. Replace control knobs. eo oo MED Push in and turn each surface unit control knob to "LITE" position.The flame should light within 4 seconds.Turn control knob to "HI" position after burner lights. Check each cooktop burner for proper flame.The small inner cone should have a very distinct blue flame 1/4" to 1/2" long.The outer cone is not as distinct as the inner cone.
PAGE 8
GaS COflversJofl burner cap Gas conversions (from Natural gas to L.P. gas; or from L.Rgas to Natural gas) must be done by a qualified installer. Place Natural gas orifice spuds in plastic parts bag for future use and keep with literature package. Reinstall burner tube and bracket assemblies. e. Lower cooktop. Reinstall screws to secure burner tubes to cooktop. Reinstall burners, burner caps and burner grates. Do not reinstall control panel or knobs. They will be reinstalled in Step 10, Page 9.
PAGE 9
.. Close the broiler door. Press the [] Cool{top burners: "OFF" pad. a. Check that all control knobs are in the OFF position and remove the knobs. [] Remove control knobs. Reinstall the control panel. Securely tighten the 4 screws. Reinstal( the control knobs. Important: If not done in Step 8, check the "LO" flame adjustment. See "Check operation" section, Step 19, Page 7. b. Remove the control panel. (See Step 17a, Page 7.
PAGE 10
Moving the range: Tip Over Hazard A child or adult can tip the range and be killed. Connect anti-tip range foot. bracket to rear Reconnect the anti-tip the range is moved. Failure to follow these can result in death or burns to children and bracket, if instructions serious adults. When moving range, slide range onto cardboard or hardboard to prevent damaging the floor covering. If removing the range is necessary for cleaning or maintenance: 1. Unplug range or disconnect power. 2.
PAGE 11
For cleanin9 and maintenance... if range does not operate: If removing the range is necessary for cleaning or maintenance, disconnect the electric supply. []Check that the circuit breaker is not tripped or the house fuse blown. If electrical supply is inaccessible, lift the range slightly at the front and pull the range away from the wall. Pull the range out only as far as necessary to disconnect the electrical supply line. Remove the range to complete cleaning or maintenance.