Instructions / Assembly

ManualsBrandsWhirlybird ManualsHeating, Ventilation, and Air Conditioning14 in. Weathered Bronze Aluminum Externally Braced Wind Turbine

1.800.643.5596 • Lomanco, Inc. • lomanco.com

Twitter

Find us on

Facebook

To determine roof pitch, place gauge

on peak of roof as shown. Position straight

edge as shown. Read roof pitch from printed

gauge parallel to bottom of straight edge.

Align roof pitch number on elbow

with the indicator line on the base flashing.

Place 3 screws through holes that line up

with predrilled holes in base.

Locate base opening between rafters

and mark hole to be cut. Locate rafters by

tapping roof.

Rotate top of elbow to level position

by turning counter clockwise.

Slide top half of flashing under

shingles. Secure with nails at top, sides and

bottom.

Cut hole as marked. Seal around

entire perimeter of hole with roofing cement.

Place locking clamp across seam and

tighten as shown with included screw.

Seal the adjusting seam and the

base/elbow connection seam on inside with

roofing cement. Seal locking clamp holes and

all exposed nails with roofing cement.

Position the Whirlybird® turbine

head on the base. Line up the predrilled

holes in the brackets and elbow and fasten

with sheet metal screws.

After installing, check to see that

Whirlybird® turbine vent turns freely. In

transportation it may have shifted slightly. If

necessary, minor adjustment may be made

by gently prying lowest point of turbine

upward to remove any wobble.

20000_0413

GUARANTEE

Lomanco, Inc., guarantees this product against defects due to

workmanship, parts, or mechanical failure forever. For replacement

of the defective product send it, freight prepaid to Lomanco, Inc.,

2101 West Main Street, Jacksonville, AR 72076. If the unit is defective,

it will be replaced with a new unit at no charge and returned, freight

prepaid. Guarantee does not include replacement due to destructive

storms. Guarantee is transferable from the original owner to

subsequent owners.

GUARANTEE APPLIES TO RESIDENTIAL ATTIC USE ONLY AS

AN EXHAUST VENT IN A BALANCED VENTILATION SYSTEM.

GUARANTEE IS VOID IF USED ON FIREPLACE, CHIMNEY, STOVEPIPE

OR ANY

APPLICATION OTHER THAN AS INTENDED BY LOMANCO.

Tools Needed:

• Screwdriver

• Level

• Jig Saw

• Putty Knife

• Utility Knife

• Drill

• Hammer

• Tape Measure

Model BIB & BEB Installation Instructions

Summary of content (2 pages)

PAGE 1
Model BIB & BEB Installation Instructions 1 2 3 4 5 6 7 8 9 To determine roof pitch, place gauge Align roof pitch number on elbow Locate base opening between rafters on peak of roof as shown. Position straight with the indicator line on the base flashing. and mark hole to be cut. Locate rafters by edge as shown. Read roof pitch from printed Place 3 screws through holes that line up tapping roof. gauge parallel to bottom of straight edge. with predrilled holes in base. Cut hole as marked.
PAGE 2
How To Locate and Space The Original! 1/4 Tu rbi n e Ve nt 1/6 1/4 Back of House CENTER 1/6 Back of House Proper Spacing With Two Whirlybird® Turbine Vents Installed Proper Spacing With Three Whirlybird® Turbine Vents Installed Whirlybird® turbine vents should be located near the peak of the roof on the rear slope, exposed to the wind from all directions. When installing two, place each one ¼ of the total length of the roof peak from each end of the house.