Litter-Robot 3 Connect Self-Cleaning Litter Box – Grey Manual

10
Toll Free: 877-250-7729 www.Litter-Robot.com
Ongoing Maintenance
Empty the Waste Drawer when indicated by the
flashing blue light on the Control Panel.
How often you will need to empty the Waste drawer
depends on the number and size of your cats. For two
average-sized cats, twice per week is typical. For a single
cat, once per week is usually sufficient.
Pull out the Waste Drawer using the handle below the
step, then gather the edges of the liner bag and dispose.
You can use Litter-Robot custom-fit, biodegradable Waste
Drawer liners or any 10-13-gallon trash bags.
To install a new drawer liner, open the bag and roll down
the edge about four times. Starting at the back of the
drawer, push the rolled edge of the bag into each of the
four tabs, keeping the bag taut as you work forward.
Slide the drawer back in, being careful not to push the
unit against the wall or into a corner (must not be
touching any walls). Then, press the Reset button to
reset the Cat Sensor.
Add litter as needed.
Check the litter level once per week or each time you
empty the Waste Drawer. Add just enough litter to meet
the raised Fill Line inside the Globe, and be careful not to
overfill it. After adding or removing litter, press the Reset
button to reset the Cat Sensor.
Press the Reset button.
Any time you affect the weight or placement of the unit
(including emptying the Waste Drawer, adding or
removing litter, or cleaning or moving the unit), press the
Reset button to ensure the Cat Sensor will detect your
cat and cycle properly.
See
Use and Care
on page 25 to learn about the Carbon
Filter, Base Seal Strips, Waste Drawer Liners, and how to
clean the Litter-Robot.