Litter-Robot 3 Connect Self-Cleaning Litter Box – Grey Manual

18
Toll Free: 877-250-7729 www.Litter-Robot.com
Red Light: Cat Sensor Activated and Wait Time Countdown
The Cat Sensor has been activated by a cat entering the
Globe. Once the cat exits, the Wait Time countdown to a
Clean cycle will begin (see page 23). You can cancel the
timer (red light) by pressing Reset.
Red Light Flashing: Cat Sensor Fault
The Cat Sensor has been continuously activated for 2
minutes or more, either by a cat that won’t leave the
Globe or by too much weight in the unit.
Check for excess weight, such as too much litter or
waste. When you are done, press the Reset button or
turn the unit off then back on to reset the Cat Sensor.
Yellow

Red Lights Flashing Sequentially:
Motor detects obstruction or jam.
Turn unit off and remove Bonnet and Globe. Check for
gear/motor obstruction. Reassemble unit and verify
proper litter level. Power on and let cycle. If problem
persists, contact Customer Service.
Blue

Yellow

Red Flashing Sequentially:
Cannot find Dump position.
Unit will continue to function in Automatic Mode. Contact
Customer Service.
Red

Yellow

Blue Flashing Sequentially:
Cannot find Home position.
Unit will continue to function in Automatic Mode. Contact
Customer Service.
Blue-Yellow-Red Flashing Simultaneously:
Cannot find Home or Dump positions.
Unit will not cycle. Contact Customer Service.