Litter-Robot 3 Connect Self-Cleaning Litter Box – Grey Manual

23
Toll Free: 877-250-7729 www.Litter-Robot.com
Wait Time Setting
The Wait Time is the elapsed time starting from when your
cat exits the Globe until the unit starts a Clean cycle. It can
be set for 3, 7, or 15 minutes. The default Wait Time is 7
minutes.
Reduce the Wait Time if it is important to minimize odor
and/or the time that waste is available to other pets—such as
dogs. However, reducing the Wait Time may reduce the
cleaning effectiveness if clumps do not have enough time to
set up. Extend the Wait Time when using a lower quality
clumping litter that needs more time to set up.
Press and hold the Empty button for about 5 seconds to
enter Wait Time Setting mode. One of the lights will start
flashing, indicating the current Wait Time Setting. Use the
Reset button to toggle to the next setting: blue for 3 minutes,
yellow for 7 minutes, and red for 15 minutes. Press and hold
the Empty button to save the setting. The blue light will blink
to confirm, then return to standby.
Control Panel Lockout
Control Panel Lockout disables button functions to prevent
unwanted changes. The Litter-Robot functions normally in
Automatic Mode during Control Panel Lockout.
Press and hold the Reset button for about 5 seconds to enter
or exit Control Panel Lockout. The blue light will blink to
confirm status.
While in Control Panel Lockout, you can still turn the unit off
by pressing and holding the Power button for 3 seconds.