Litter-Robot 3 Connect Self-Cleaning Litter Box – Grey Manual

27
Toll Free: 877-250-7729 www.Litter-Robot.com
Cleaning the Globe
1. Press the Empty button to cycle the Globe
clockwise, which will allow the litter to fall
through the Waste Port and into the drawer for
easy disposal. Sweep any leftover litter toward
the Waste Port. Then, press any button to return
the Globe to the Home position. Ensure that
all
litter has been removed from the Globe—wet
litter turns into messy clay!
2. Turn the Litter-Robot off and unplug the unit.
3. Remove the Bonnet: Press and release the snap
tabs on both sides of the Bonnet, then lift and
rotate the Bonnet off of the Globe and carefully
set it aside.
4. Remove the Globe: With two hands, lift the
Globe off the Base.
5. Clean the Globe with water and a mild soap.
There are no electronic components in the Globe
that can be damaged by soap and water. If the
Globe has become extremely dirty, it can be
soaked and cleaned with a water hose or power
washer.
6. Let the Globe dry
completely before reassembling
it to the Base and attaching the Bonnet (see
page 28-29).
For a quick touchup, you can use a disposable
towelette to wipe the inside and upper half of the
Globe (without removing the litter). The Litter-Robot
can be used immediately, since drying is nearly
instantaneous.
Cleaning the Waste Drawer
1. Pull the drawer out.
2. Remove the carbon filter.
3. Clean drawer with soap and water.
4. Make sure the carbon filter is dry before
reinstalling it.