Litter-Robot 3 Connect Self-Cleaning Litter Box – Grey Manual

28
Toll Free: 877-250-7729 www.Litter-Robot.com
Cleaning the Base
 Never submerge or soak the Base. The Base contains
the Cat Sensor and electronics.
 Wipe the surfaces of the Base with a cloth dampened
with a disinfectant. If using a spray, spray away from
the Base directly onto a cloth or paper towel, so
disinfectant does not get on the electronics.
 Do not use bleach.
Reinstalling Globe and Bonnet
See diagrams on next page.
1. Place the Globe on the Base in the approximate
Home position (black lip of opening at bottom) with
the gear track aligned with the groove in the Base.
Note: The rotational axis of the Globe is positioned
at a 20-degree angle relative to the floor, so the
Globe is installed slightly tilted in the Base.
2. Rotate the black Key at back of Globe into the pocket
of Base.
3. Find the tabs at the bottom and rear of the Bonnet.
Align and insert the tabs into slots in the Base.
4. Rotate the Bonnet downward with light pressure on
the sides such that Bonnet hugs the Globe. This will
help to ensure proper alignment of the Bonnet snaps
with the slots in the Base. Once the Bonnet snaps
have entered the slots, push down on the Bonnet
from the top and make sure the Bonnet snaps have
latched into place and Bonnet is secure.
Note: The unit will not run without the Bonnet
installed.