Litter-Robot 4 Automatic Litter Box - Manual

www.whiskersuppo.com

Seing Up Your Lier-Robot

Your Lier-Robot comes fully assembled and ready to use. Get staed by following

the steps below.

Placement

 If possible, place the Lier-Robot in the same location as the old lier box (at least

during transition).

 Make sure the unit is on a rm, level suace. Avoid so, uneven, or unstable flooring.

 Keep the unit indoors in a cool, dry location. Reduce exposure to high temperature

and humidity. If possible, keep out of direct sunlight.

 Place the unit near a power outlet. Ensure the unit isn't pushed against a wall or into a

corner (must not be touching any walls).

 Place lier mats or rugs in front of, or completely under, the unit. Do not place mats

paially under the unit. Use only low pile (1/4 inch) rugs and mats under the unit.

DO NOT use liers that are the strictly absorbent, non-clumping, loose-clumping,

newspaper-based, or wood-based pellets.

Lier

Fill the Globe through the circular opening

with clumping lier until it meets the

raised MAX Fill Line when spread flat—

approximately 8-10 pounds (3.6-4.5 kg) by

weight or 1 gallon (4L) by volume. Be careful

not to oveill the Globe.

The Lier-Robot lier siing system requires

clumping lier to work properly. We

recommend a high-quality, clay-clumping

lier. Lier beads and crystals that are small

enough to pass through the screen will also

work (periodic changing of this type of lier

is required).

Litter

Fill line