Litter-Robot 4 Automatic Litter Box - Manual

www.whiskersuppo.com
16
Clean Cycle
Aer your cat leaves the Globe, the Lier-Robot automatically peorms a Clean cycle. The
siing system separates the clumps from the clean lier and deposits them into the Waste
Drawer below. It will take 2 minutes to complete the Clean Cycle. You can also press the
Cycle buon to sta a Clean cycle.
During a Clean cycle, press any buon to pause the cycle. Press the Cycle buon to resume
the cycle. Press the Reset or Empty buon to abo the cycle and return the Globe to the
Home position.
How it works:
The Lier-Robot is ready for use when the Globe is at the Home position and the Light Bar on
the Control Panel is blue.
1. When a cat enters the Globe, the Cat Sensor(s) are activated; the blue Light Bar
changes to red.
2. Once the cat exits the Globe, a countdown to the Clean cycle begins. When the Wait
Time (see page 24) has elapsed, the red Light Bar changes to a yellow round robin
Light Bar indicating the counterclockwise Globe rotation of the Clean cycle.
3. As the counterclockwise rotation continues, clean lier passes through the
low-dust screen while lier clumps are separated from the clean lier. The clean
lier is collected behind the septum.
4. During rotation, and while the Globe is upside down, an integrated weight within the
boom of the Flexible Globe Liner causes the liner to fall away from the Globe to
ensure any stuck-on clumps are removed.
5. As the Globe rotates toward the Dump position, the waste clumps fall through the
Waste Po into the Waste Drawer below.
6. The Globe then stops at the Dump position and begins to rotate clockwise, back to-
ward the Home position. The Flexible Globe Liner falls back into place and clean lier
spills back into the boom of the Globe.
7. The Globe will rotate past the Home position to level the lier before nally
re turning to the Home position. The sequential round robin yellow Light Bar
changes to the blue Light Bar, indicating the unit is ready for the next use.