Litter-Robot 4 Automatic Litter Box - Manual
www.whiskersuppo.com
30
Carbon
Filter
Seal
Strips
Carbon Filter
The Lier-Robot is equipped with a flexible Carbon Filter pad
that is installed on the outer boom area of the Globe. This
lter sits directly over the Waste Drawer to absorb odors. The
Carbon Filter is easily removed and installed
by staing a Clean Cycle, then opening the Bonnet
when the Globe is at the Dump Position. Replace
the Carbon Filter as needed. Under normal use,
one lter should last approximately 1 month. The
Carbon Filter is not required for the unit to function.
Replacement Carbon Filters and other odor-absorbing
accessories can be ordered at lier-robot.com.
Base Seal Strips
The Lier-Robot is equipped with brush-type Seal Strips
on both the top and boom of the Base.
These Seal Strips help contain odors within the
Waste Drawer.
Replace the Seal Strips when you notice they are
worn flat or peeling up. Make Seal Strips last longer by
trimming loose edges between replacements. Be careful
not to get them wet when cleaning the Base or they may
begin to peel. Replacement Seal Strips can be ordered at
lier-robot.com.
Emptying the Lier-Robot
1. Press the Empty buon to cycle the Globe clockwise, which will allow
the lier to fall through the Waste Po and into the Waste Drawer for easy
disposal.
2. If lier remains in the Globe, sweep the granules toward the Waste Po.
3. Press any buon to return the Globe to the Home position.
IMPORTANT: Supervise and prevent your cat from entering during the Empty cycle,
as the unit may not detect your cat without lier in it.