Installation and Operation Guide
PART 1: HOOD INSTALLATION GUIDE
Integrated Hood
Models included: X3M06S5, X3M09S5, X3MD09S5, X3MD12S5 and X3W12S5
8
STEP 1:
To install into your overhead cupboard, several holes may need to be cut into
shelves to enable the ducting to exit the cabinetry. Ensure the hood is mounted
as close to the centre of the cooking surface as possible.
NOTE:
The height of the underside of the hood body must be a minimum of 600mm
above an electric cooktop, for a gas cooktop a minimum of 600mm above the
highest part of the highest burner and a maximum height of 1200mm. If the
instructions of the hob specify a greater distance than the minimum detailed,
this shall be the minimum height for installation.
A comfortable installation height would be 700 – 750mm gap between the
base of the rangehood and the highest part on your cooktop.
For installation over a BBQ, the hood must be installed a minimum of
1200mm above the cooking surface. Building codes that stipulate a
minimum dimension may vary from state to state, please check with your
local council prior to installation.
STEP 2:
Refer to Part 2: Motor Installation Guide.
STEP 3:
Remove the three (3) screw xings from within the Main Chassis of the
rangehood located along the rear chassis wall (located above the grease trap),
along with two (2) screws on the left side and two (2) screws on the right side.
Once the screws are removed, the Fascia will separate away from the Main
Chassis.
STEP 4:
Fixing Holes are located on the returns of the main chassis. These Fixing Holes
are used to secure the main chassis to the cabinetry.
STEP 5:
Place the Main Chassis in the cabinet ensuring that the hood is level and the
controls and display will be visible when standing in front of the unit.
WARNING
DIMENSIONS ARE ACCURATE AT THE TIME OF PRINTING, HAUS GROUP RESERVES THE RIGHT TO
CHANGE SPECIFICATIONS WITHOUT NOTICE. FOR BUILDING PURPOSES THE UNIT SHOULD BE
PROVIDED TO THE CABINET MAKER / BUILDER / KITCHEN DESIGNER FOR EXACT MEASUREMENTS.
Outlet
Bafe Filters Grease Trap
Main Chassis
Fascia
Step 3: Remove Fascia from Chassis
Fixing Holes
Step 4: Locate the Fixing Holes of the Main Chassis