Installation and Operation Guide

ManualsBrandsWhispair ManualsCooking Appliances90cm Monte Carlo Super Deep Under Cupboard Rangehood with Pro External Remote Motor

PART 2: FAN MOTOR INSTALLTION GUIDE

External Solution - Wall Mounted

Models included: EL-800, EP-1140 and EPP-2010

Positioning your KLEENAIR Unit:

It is recommended that when the KLEENAIR EXTERNAL UNIT is

WALL mounted, it is positioned a minimum 1800mm above

the ground surface with a downward clearance of 1200mm

and with a radial clearance of 600mm. Please ensure that the

KLEENAIR unit is positioned in an environment that is free of

other gases to enable an efcient expulsion of the cooking

bi-products and to ensure that back-draft of external gases

doesn’t take place.

Please ensure the fan motor is positioned away from other

exhausts such as chimneys, gas fuses, etc. The unit can be

mounted so that it ducts directly through the wall.

STEP 1:

Cut a 200mm diameter hole in the wall to enable the rigid duct

on the back of the KLEENAIR unit to protrude. Please ensure

that the hole is cut in a practical position to enable sufcient

clearance around the fan motor unit.

STEP 2:

Remove the mounting bracket from your KLEENAIR unit by

twisting the cover in an anti-clockwise direction. Mark at least

four mounting points on the wall and pre-drill the holes

required.

STEP 3:

The rigid duct may require cutting to suit your particular wall

thickness. Attach the exi-duct to the rigid duct on the back of

the mounting bracket using the pipe clamps supplied.

STEP 4:

Fix the mounting bracket to the wall using the screws and wall

plugs provided. Making sure to secure it at 90 degree’s to the

horizontal. A secondary mounting bracket (HBXP24) is

available is additional clearance between the wall and outlet is

required.

Cover

Inlet

Outlet

Mounting Holes

Primary Wall

Mounting Bracket (Supplied)

Secondary Wall

Mounting Bracket (Optional)

Locking Screw

STEP 5:

Feed the power cable through the centre of the mounting bracket and return the KLEENAIR unit onto the mounting bracket and

x it by rotating the cover in a clockwise direction noting the locating points. Lock the cover into position by tightening the locking

screw.

STEP 6:

Attach the male plug of the KLEENAIR unit to the female plug of the rangehood to enable power supply to the fan motor unit. An

extension lead (not supplied) of up to ve meters may be added if required.