Installation and Operation Guide

PART 1: HOOD INSTALLATION GUIDE

Wall Hung Canopy Hood

Models included: X5L09S5, X5S09S5, X5V09S5, X5R09S5, X5M10S5 and X5N12S5

STEP 1:

Measure the height (H1) of the hood from the base to the top of the Mounting

Hooks. Ensure the hood is mounted as close to the centre of the cooking surface

as possible.

NOTE:

The height (H2) of the underside of the hood body must be a minimum of

600mm above an electric cooktop, for a gas cooktop a minimum of 600mm

above the highest part of the highest burner and a maximum height of

1200mm. If the instructions of the hob specify a greater distance than the

minimum detailed, this shall be the minimum height for installation.

A comfortable installation height would be 700 – 750mm gap between the

base of the rangehood and the highest part on your cooktop.

For installation over a BBQ, the hood must be installed a minimum of 1200mm

above the cooking surface. Building codes that stipulate a minimum dimension

may vary from state to state, please check with your local council prior to

installation.

STEP 2:

Using a spirit level mark a vertical centre line on the wall where the Mounting

Bracket needs to be positioned. It is recommended to centre the hood unit to the

cooktop below.

STEP 3:

Mark a horizontal line on the wall for the Mounting Bracket position. Centre and

mark the four (4) xing points in the vertical section on the left and right side of

the bracket. Drill and plug holes with suitable sized wall plugs (not provided).

STEP 4:

Fix the Mounting Bracket with four (4) suitable screws into the wall at the

positions marked in step 3 to allow the body of the hood to be hung on the wall.

STEP 5:

Hang the hood on the wall ensuring the Mounting Hooks are securely positioned

into the Mounting Bracket.

WARNING

DIMENSIONS ARE ACCURATE AT THE TIME OF PRINTING, HAUS GROUP RESERVES THE RIGHT TO

CHANGE SPECIFICATIONS WITHOUT NOTICE. FOR BUILDING PURPOSES THE UNIT SHOULD BE

PROVIDED TO THE CABINET MAKER / BUILDER / KITCHEN DESIGNER FOR EXACT MEASUREMENTS.

Wall Mounting Bracket

Hood Fixing Holes (5x) - Step 6

Wall Fixing Holes (4x) - Step 4