Installation and Operation Guide

PART 2: FAN MOTOR INSTALLTION GUIDE

Inline Solution

Models included: IL-800 and IP-1140

Positioning your KLEENAIR Unit:

It is recommended that the KLEENAIR INLINE unit be mounted

in a roof space or wall cavity. Please ensure that the KLEENAIR

unit is positioned in an environment that is free of other gases

to enable an efcient expulsion of the cooking by-products

and to ensure that back draft of external gases doesn’t take

place.

Please ensure the fan motor is positioned away from other

exhausts such as chimneys, gas ues, etc. The inline unit can

be mounted so that it ducts directly through the wall or eave

vent.

STEP 1:

Establish a suitable position in the roof or wall cavity for the

KLEENAIR unit, ensuring that the distance between the

KLEENAIR unit and the outside vent is no greater than

800mm. The KLEENAIR unit must be located a minimum

of 3 metres from the hood unit.

STEP 2:

Using the mounting bracket and screws, mount the KLEENAIR unit to a beam, truss or another appropriate structures in the roof

or wall space through the rubber grommets. Hang the fan motor unit from the mounting bracket ensuring the mounting bracket

is located at the top of the unit. Ensure the direction of airow is toward the outside. The direction of airow is marked on the

KLEENAIR unit.

STEP 3:

Cut a 200mm diameter hole in the wall or eave to enable the mounting of the external vent. Please ensure that the hole is cut in

a practical position to enable the exi-duct to be secured. Attach the exi-duct to the vent and then mount vent to the wall or

eave.

STEP 4:

Attach the exi-duct from the external vent to the outlet of the KLEENAIR unit using pipe clamps. To minimise inefciencies and

noise ensure the duct is pulled tight and the 200mm diameter is maintained.

STEP 5:

Attach exi-duct from the KLEENAIR unit to the rangehood using pipe clamps. Ensure that the duct is pulled tightly to ensure that

exi-duct remains rm and stable during operation. Avoid sharp bends in the duct.

Gentle bends in the ducting are

recommended as it assists in mufing noise from the fan motor unit back to the rangehood

. If the exi-duct needs to be

extended attach two exi-duct ends using a rigid duct insert and secured by pipe clamps (Optional installation accessories

HBX200DUCT).

STEP 6:

Attach the male plug of the KLEENAIR unit to the female plug of the rangehood to enable power supply to the fan motor unit. An

extension lead (not supplied) of up to ve meters may be added if required.

OutletMounting Bracket

Inlet