User Manual

Specifications
· Dimensions: 2.1” x 1.3” x 0.6” · LED color: Red
· Weight: 1.2 oz · Frequency: 433.92 MHz
· Power Requirements: (2) CR2450, lithium, coin cells · Low Battery Indicator
· LED Boom length: 5.5” · On/Off Switch
· Battery Life: Approximately x hours
(Please refer to Cruisader Owner’s Manual for Warranty Information)
Battery Replacement
1. Remove the screws from the rear cover.
2. Remove the rear cover.
3. Raise the LED end of the printed circuit board and slide it towards the LED to clear the
switch from the housing.
4. Raise the switch end of the printed circuit board to allow access to the batteries.
5. Remove the assembly from the housing.
6. Slide the top battery away from the slide switch and remove. Raise the lower battery
upward to clear the hole in the printed circuit board and slide it in a similar fashion.
7. Insert the replacement battery 1 with the (-) contact into the hole in the printed circuit
board. Insert replacement battery 2 (+) contact up, onto the top of battery 1. Replace the
assembly into the housing in a reverse manner.