User's Manual

Advanced Settings

The menus for each type of object include various settings for LED,

Backlight and Alarm. You can use these settings to design custom

visual and/or audible alarms that are triggered when activity is

detected on the speciﬁed Scannable Object.

Notes:

• The Alert LED utilizes a special tri-color Light Emitting Diode

module that mixes light from red, green and blue LED elements

to produce thousands of different colors. Eight pre-deﬁned color

settings are available for use in object menus. LED COLOR: 0 is

normally used for “all colors off” or no Alert LED display.

• Slight variations to LED colors are a normal part of the

manufacturing pr

ocess. You may notice these variations when

using the White LED color setting (LED COLOR: 7), or when

comparing one PRO-652 to another. You can compensate for

these slight variations by fine-tuning the Red/Green/Blue (RGB)

LED settings for each color. See the COLOR settings in the GLOB

menu in “Appendix B: Detailed Menu Reference: GLOB Menu” on page 96.

To set the Audible Alarm and Alert LED:

In any object menu:

1. Press q to scroll to any of the following settings.

•

LED Mode: Solid or Flash controls whether the LED remains on

solid or ﬂashes when the object is active.

• LED Color: 0-7 sets the color of the LED. By default, color 0

is used for LED off. You can change the preprogrammed LED

colors in the Global Settings menu.

• Latch LED Keeps the LED on after activity on the object is

ﬁnished. This is useful when you need to know if an object was

active while you were away from the scanner.

• Backlight: Off, On, Flash controls whether the backlight

remains off, comes on solid or ﬂashes when the object is active.