User Manual

MOUNTING THE MONITOR

Find a mounting surface inside the vehicle for the monitor

where it can be easily seen, and does not obstruct your

vision when driving.

NOTE: To maximize the effectiveness of the suction mount,

the mounting location surface temperature should be

between 50° and 100°F. Avoid application below 50°F.

NOTE: Before permanently mounting the monitor, test the

reception of the camera signal in several selected locations

within easy reach as one may have better reception than

another. If mounting to the dashboard, the dash disk must

be used to ensure a smooth surface for the suction cup to

attach.

1. Clean and dry the mounting surface before applying

suction cup or dash disk.

2. Press the suction mount against the mounting surface

and push the suction lock lever down. Make sure the

mount is attached securely.

3. Slide the monitor onto the monitor arm. The monitor

angle can be adjusted by loosening the monitor angle

adjustment knobs, tilting the monitor, then tightening

the knobs.

4. Plug the monitor power cord into a 12-volt DC power

port inside the vehicle.