User Manual

TEST THE CAMERA

Test the Camera

Prior to attaching the license plate to your vehicle, follow the

steps below to ensure pairing between the backup camera

and monitor.

1. With power applied to the monitor, the button backlight

will illuminate to indicate the monitor is ON and in

Standby mode.

2. The Blue LED will blink briefly to indicate that it is

attempting to communicate with the camera. When

connected to the camera, the blue LED will turn solid.

It may take a moment for the camera to begin sending

the video information. Allow time for the image to be

displayed.

3. The image is set to time out in 60 seconds however if you

wish to shut the image off manually, touch anytime

that video is present to stop the video transmission and

put the camera back into the power conserve mode. (The

blue LED will shut off when the timer expires)

4. If the 12-volt DC power port in your vehicle is live all

the time the backlight will stay on constantly. To shut

the button backlight off, touch and hold the button

for 3 seconds. The monitor retains this setting and must

be turned back on in order to receive video. This can

be done easily with a touch of the button. Standby is

confirmed when the button backlight remains ON.

NOTE: If the monitor has been shut off with button,

removing the power source and reapplying will not turn your

monitor on as the OFF function is stored in memory and the

unit must be turned ON by touching the button.

NOTE: If using a switched 12-volt DC Power port, it is not

necessary to power off the monitor unless you do not wish to

receive an image automatically when starting your vehicle.