pro1200to3000w.qxp 4/30/2010 8:54 AM Page 1 OWNER’S MANUAL Pro-1200W, Pro-1600W Pro-2000W, Pro-2500W Pro-3000W POWER INVERTERS THE WHISTLER GROUP, INC. CORPORATE HEADQUARTERS 3604 N.W. Frontage Rd. Bentonville, AR 72712 TEL (479) 273-6012 FX (479) 273-2927 www.whistlergroup.com CUSTOMER RETURN CENTER 551 N. 13th St. Rogers, AR 72756 Customer Service Tel (800) 531-0004 Email: info@whistlergroup.com P/N 401516 © 2010 The Whistler Group, Inc.
pro1200to3000w.qxp 4/30/2010 8:54 AM Page 3 INTRODUCTION If you have questions concerning the operation of this Whistler product please call customer service: 1-800-531-0004 Hours: Monday - Friday 8:00 am - 5:00 pm CT Please keep the receipt in a safe place. You may register your product online at www.whistlergroup.com. If the unit is returned without a dated proof of purchase, an out of warranty service charge applies. Note: Your warranty period begins at the time of purchase.
pro1200to3000w.qxp 4/30/2010 8:54 AM Page 5 TABLE OF CONTENTS Topic WHISTLER FEATURES Page Features Summary ..................................................................3-5 Important Information................................................................6 Inverter Information ..............................................................7 - 9 • Getting Started • Don’t Push It Battery Information ...........................................................
pro1200to3000w.qxp 4/30/2010 8:54 AM Page 7 FEATURES 1. Three 110 AC Outlets 2. Remote Operation Jack The inverter is designed to be operated from a remote location via a WHISTLER Remote Control Switch (P/N Pro-RS01) which plugs into this socket. This optional accessory is available through WHISTLER or your WHISTLER dealer. 3. USB Power Port This port is always on and independent of the inverter’s on/off switch. 4. On/Off Switch Turns the unit On/Off. 5. Digital Power Meter 6.
pro1200to3000w.qxp 4/30/2010 8:54 AM Page 9 IMPORTANT INFORMATION Important Information About Your New Whistler Inverter. This manual will provide you with directions for the safe and efficient operation of your Whistle Power Inverter. Read the manual carefully before using your new Whistler inverter and keep the manual on file for future reference.
pro1200to3000w.qxp 4/30/2010 8:54 AM Page 11 INVERTER INFORMATION Don’t Push It. Although your Whistler power inverter has the capacity to provide power output (excess current) equal to approximately two times its rated wattage capacity for a very brief period, it is designed to operate equipment and appliances with start up load wattage ratings no higher than its own maximum continuous wattage rating. For example, the Pro-1200W model has a maximum continuous rating of 1200 watts.
pro1200to3000w.qxp 4/30/2010 8:54 AM Page 13 BATTERY/CABLE INFORMATION BATTERY INFORMATION 1. 2. To calculate the Ah of the battery, first determine its "reserve minutes" rating. (Deep cycle marine batteries generally have the highest reserve minute ratings). This rating typically is marked on the battery along with the "Cold Cranking Amps" (CCA) rating. Multiply the reserve minutes rating of the battery by 0.3 to determine the battery approximate Ah rating.
pro1200to3000w.qxp 4/30/2010 8:54 AM Page 15 OPERATION CABLE INFORMATION Pro-2000W and Pro-2500W Making the Connection. When the inverter and the battery are set up within three feet of each other, use a minimum of #2 gauge wire to make the connections. Within four to six feet, use a #0 gauge wire (Pro-2000W), #00 gauge for Pro-2500W. At distances between six feet to ten feet, use #000 gauge wires (Pro2000W), #0000 for Pro-2500W connected in parallel to the battery. 1.
pro1200to3000w.qxp 4/30/2010 8:54 AM Page 17 OPERATION OPERATION Note: • Loose connections can result in a severe decrease in voltage which may cause damage to the wires and insulation. • Failure to make proper connection between the inverter and the power source will result in reverse polarity. Reverse polarity will blow the internal fuses in the inverter and may cause permanent damage to the inverter. Damage caused by reverse polarity is not covered under the Whistler warranty.
pro1200to3000w.qxp 4/30/2010 8:55 AM Page 19 OPERATION • Check frequently to ensure that the input and output connections are secure. Loose connections may damage the inverter, the power source, or may generate excessive heat. To generate the maximum output, the Pro-3000W watt model (for example) should be connected to a power supply which has the capacity to produce up to 300 amps.
pro1200to3000w.qxp 4/30/2010 8:55 AM Page 21 OPERATION OPERATION 2. Change the relative positions of the inverter, antenna cables and television power cord. 3. Isolate the television, its power cord and antenna cables from the 12 volt power source by running an extension cord from the inverter to the television set. 4. Coil the television power cord and the input cables running from the 12 volt power source to the inverter.
pro1200to3000w.qxp 4/30/2010 8:55 AM Page 23 OPERATION For You Technical Types. 1. Basic Operating Principles: Whistler inverters work in two stages. During the first stage, the DC to DC converter increases the DC input voltage from the power source (e.g. a 12 volt battery) to 145 volts DC. In the second stage, the high voltage DC is converted to 110 volts (60 Hz AC) using advanced power MOSFET transistors in a full bridge configuration.
pro1200to3000w.qxp 4/30/2010 8:55 AM Page 25 OPERATING PRINCIPALS/SUMMARY In Review. • • Never attempt to operate your Whistler inverter from any power source other than a 12 volt battery or a group of batteries that total 12 volts. Always make certain that the power cable terminal connections Negative (-) to Negative (-) and Positive (+) to Positive (+). Check these connections frequently to ensure that they are secure.
pro1200to3000w.qxp 4/30/2010 8:55 AM Page 27 TROUBLESHOOTING TROUBLESHOOTING PROBLEM: TV Interference Overload LED on Problem Solution Electrical interference from filter inverter. Add a Ferrite data line on to the TV power cord. This filter is available at electronic supply stores. PROBLEM: Low or No Output Voltage Problem Solution Using incorrect type of Use true RMS reading meter voltmeter to test output See "For You Technical voltage. Types" Section of this manual.
pro1200to3000w.qxp 4/30/2010 8:55 AM Page 29 SPECIFICATION Pro-1200W WATT INVERTER SPECIFICATIONS Maximum Continuous Power . . . . . . . . . . . . . . . . . . . .1200 Watts Maximum Surge Capability (Peak Power) . . . . . . . . . .2400 Watts* No Load Current Draw . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .< 1.0A Waveform . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Modified Sine Wave Operating Input Voltage Range . . . . . . . . . . .11-15+0.5 Volts DC AC Receptacle . . . . .
pro1200to3000w.qxp 4/30/2010 8:55 AM Page 31 WARRANTY WARRANTY Consumer Warranty The Whistler Pro series inverters are warranted to the original purchaser for a period of (2) two years from the date of original purchase against all defects in materials and workmanship. This limited warranty is void if the unit is abused, modified, installed improperly, had its housing removed, or has a missing serial number.
pro1200to3000w.qxp 4/30/2010 8:55 AM Page 33 WARRANTY MEMO The out of warranty service fee for the Pro Series inverters are as follows: Pro-1200W inverter is $75.00 Pro-1600W inverter is $95.00 Pro-2000W inverter is $125.00 Pro-2500W inverter is $155.00 Pro-3000W inverter is $185.00. If you require out of warranty service, please return your inverter as outlined in the section “Service Under Warranty” along with a certified check or money order for the correct amount.