Owner`s manual

The following steps outline the options
available for select features.
1) Press Menu (M) untill one of the selectable
features is displayed.
2) Press Enter (E) to show one option.
3) Press M to view all options.
4) Press Er to save the option shown.
NOTE:
SPD = SP 1= MPH/Yards, SP 2 = KPH/Meters
LSPD = Select the speed at which the unit will
alarm
LOCA =
Select the correct time- correction for your
area
ALAR = Select the “Top of the Hour” alert
REST = Select stay alert
OPERATION
OPERATION
Camera Alerts
When a camera location is approached, the
unit will announce the type of alert (Red Light
Camera, Speed Camera, or User Selected), for
example, “Caution red light camera detected”
and the display counts down the distance to
the camera.
Two alert LEDs on either side of the display will
flash faster as you get closer to the camera.
Once past the camera location, the unit will
provide an “all clear” beep-beep type audio
tone.
IMPORTANT: The RLC-100 is a red light/speed
camera locator and does not detect laser or
radar signals.
Manual Entry
The RLC-100 will save a special location (i.e., a
new red light camera or even a “trap”) if you
enter it manually. The unit will store 100 user
locations.
NOTE: Manual enteries must be
approximately 100 yards apart to prevent
overlapping locations.
14 15
To manually enter a location, simply press
Enter (E) and the unit will announce “user
point logged”.
When detecting this position, the unit will
announce “warning user position ahead” the
next time it approaches this location..
To delete manual locations:
When the unit is alerting a manual location,
press Enter (E) and unit will announce “user
position deleted”.
To delete all manual locations:
1) When the unit is alerting a manual location,
press and hold Enter for more than 2 seconds.
The unit announces “user position deleted”
and displays “
AADDEELL
” . Press Enter again to
delete all manual locations.
If Enter is not pressed within 5 seconds after
“
AADDEELL
” is shown, the locations ar
e saved and
the mode is exited.
16
OPERATION
Press the Enter (E)
b
utton to save a
new location.