Owner`s manual

CARE & MAINTENANCE
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2)This device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
IMPORTANT: FCC requirements state that
changes or modifications not expressly approved
by The Whistler Gr
oup could void the user’
s
authority to operate the equipment.
During the summer months, avoid
prolonged exposure to direct sunlight by
r
emoving your unit from the dash when your
vehicle is parked for an extended
period of time. Do not spray water,
cleaners, or polishes directly onto the unit.
The spray may penetrate through the
openings and damage the unit. Also, do not
use any abrasive cleaners on the unit’s
exterior.
18
19
20
Y
our unit is expertly engineered and designed
to exacting quality standards to provide you
with reliable, trouble-free operation. If your unit
has been correctly installed following the
guidelines in this manual, but is not operating
optimally, please refer to the troubleshooting
guide below.
PROBLEM: No display or audio.
Check fuse in Whistler plug; replace if
necessary with a 2 amp, 3AG type. Check fuse
for lighter socket; replace if necessary. Make sure
lighter socket is clean.
PROBLEM: Audio alerts are not loud
enough. Check audio level setting (see
pg.10).
PROBLEM: Unit resets when vehicle hits
bumps. Check for loose lighter socket; tighten
and clean. Check connections at both ends of
power cord. Substitute another cord to
determine if cord is defective. Return
defective cord to the factory.
If difficulties occur which cannot be solved by
information in this Troubleshooting Guide, please
call Whistler Customer Service at
11--880000--553311--00000044
or visit our FAQ page at
wwwwww..wwhhiissttlleerrggrroouupp..ccoomm
befor
e r
eturning your
unit for service.
TROUBLESHOOTING GUIDE FCC INFORMATION