User Guide

66
03-02 Cluster size bad Reinsert the MicroSD card to ensure it is fully inserted
in locked in the MicroSD slot. If necessary, reformat
the MicroSD card using the PC Application "Prepare
MircoSD Card for use" option. Replace the MicroSD
card if the problem persists.
03-03 Error reading
SD card
Reinsert the MicroSD card to ensure it is fully inserted
in locked in the MicroSD slot. If necessary, reformat
the MicroSD card using the PC Application "Prepare
SD card for use" option. Replace the MicroSD card if
the problem persists.
03-04 Error writing SD
card
Reinsert the MicroSD card to ensure it is fully inserted
in locked in the MicroSD slot. If necessary, reformat
the MicroSD card using the PC Application "Prepare
SD card for use" option. Replace the MicroSD card if
the problem persists.
03-05 MicroSD card
is full
Reduce size of configuration, remove unnecessary
audio recordings or switch to a MicroSD card with
more capacity.
03-06 MicroSD card
write protected
Reinsert the MicroSD card to ensure it is fully inserted
in locked in the MicroSD slot. If necessary, reformat
the MicroSD card using the PC Application "Prepare
SD card for use" option. Replace the MicroSD card if
the problem persists.
03-07 Mass storage
mode is active
Under normal conditions this error should not appear.
Mass storage device mode is disabled when the
scanner is connected to a computer and scanning.
Disconnect the radio from the computer, wait a few
seconds, then reconnect. Contact Support if the
problem persists.
03-08 Unknown MicroSD
card read/write
error
Reinsert the MircoSD card to ensure it is fully inserted
in locked in the MicroSD slot. If necessary, reformat
the MicroSD card using the PC Application "Prepare
SD Card for use" option. Replace the MicroSD card if
the problem persists.
04-00 Initialization error Contact Support and provide error code information
04-01 Initialization error Contact Support and provide error code information
04-02 Firmware load
error
Contact Support and provide error code information
05-00 Unable to load
CONFIG_.BIN
Reformat the SD card using the PC Application
"Prepare SD Card for use" option. Replace the SD
card if the problem persists.
05-01 CONFIG_.BIN
file error
Reformat the MicroSD card using the PC Application
"Prepare SD Card for use" option. Replace the
MicroSD card if the problem persists.
05-02 CONFIG_.BIN
file error
Reformat the MicroSD card using the PC Application
"Prepare SD Card for use" option. Replace the
MicroSD card if the problem persists.
05-03 CONFIG_.BIN
file error
Reformat the MicroSD card using the PC Application
"Prepare SD Card for use" option. Replace the
MicroSD card if the problem persists.