User Manual

11
Detaching and Attaching
Remote Head and Base Unit
To detach the (Remote Head Unit) from the (Base Unit),
Press and hold the release button on the left side of
the base unit. A gap will appear between the base unit
and the remote head unit. Grasp the remote head and
carefully remove it from the base unit.
If the scanner was on, it will continue to scan, but you
will not be able to make changes until you reconnect
the head or cable to the head unit.
To link the base unit and remote head unit, connect
them using the supplied 8P8C Type B Straight Cable.
To reattach the remote head to the base, unplug the
LAN cable from both units and align the guide pins
on the right side of the remote head with the slots on
the base unit. Then, carefully press the remote head
into the base unit, keeping your fingers out of the gap
between the remote head and the base. The magnets
will “grab”, holding the remote head in place. The
remote head unit can be attached to an AMPS or Lido
mount (not included) if desired.
WARNING: Always install the remote head with care,
keeping your fingers clear; the magnets are very
powerful. Always keep the magnets well away from
persons wearing electrical medical devices such as
pacemakers, as the magnets may cause the devices to
malfunction, endangering the wearer’s life.
Base Unit
Press Here Remote Head