User Manual

NOTE: If desired, you may also connect an external

base station antenna equipped with a BNC male

connector to the antenna connector. Please refer to the

section entitled “Connecting Antenna” for important

instructions and warnings.

NOTE: An external antenna is required for mobile

operation.

Mobile Operation

By attaching the mounting bracket above the radio,

you can mount the radio underneath your vehicle’s

dashboard, or in any other mounting location where the

radio will be suspended from above. You may also use

the mounting bracket beneath the radio, which makes it

possible to mount the radio on top of any flat surface in

your vehicle.

Select amounting location that does not interfere with

visibility while driving. Use caution to select a location

that will not interfere with the deployment of your

vehicle’s air bags. It is extremely important not to

mount this or any other equipment in locations where

deployment of the air bags may cause the equipment

to be propelled towards the vehicle’s passengers. If

necessary, seek advice from your automotive dealer or

service shop.

Use the mounting bracket as a template to mark

the locations for the two mounting screws. At the

marked locations, drill holes that are slightly smaller

than the screws. Use caution not to damage wiring or

components that are located behind the mounting

surface. Using the provided screws and lock washers,

attach the mounting bracket to your vehicle.

Attach the two self-adhesive rubber washers to the

inside of the mounting bracket sides, over the holes

that are used when attaching the bracket to the

scanner’s side holes.

The rubber washers help protect the scanner’s case

from scratches.

Slide the scanner into the mounting bracket assembly,

and use the two provided knurled knobs to secure the

scanner within the mounting bracket.

Connect the supplied DC power cable to a power

source in your vehicles as follows:

Disconnect the cable from the negative (-) terminal

of your vehicle’s battery prior to attempting any

connections to your vehicle’s electrical system.

NOTE: Disconnecting your battery may reset certain