Technical data

Select anti-crease function if required.
Press the coloured Start button to commence the drying cycle. The drum will begin rotating and will stop
automatically when your clothes are dry or the timed cycle has finished. An audible alert will sound to indicate
that the drying cycle has finished.
If you have selected the anti-crease function, the drum will continue to turn periodically for up to 8 hours or until
the dryer is stopped by opening the dryer door or by disconnecting from the mains.
If the door is opened during a drying cycle the dryer will stop. To restart, close the door, press the Activate button
then press the coloured Start button.
There is an automatic 12 minute cool down period at the end of each cycle, during which the heater is switched off
and the green cool indicator is on. This helps to minimize creasing, and must always be used fully to avoid the risk
of fire.
DELAY START
To use the Delay Start feature press the Delay Start button before pressing the Start button. The Delay Start
display will show 1 hour of delay time. Repeated pressing, or holding down, of the Delay Start button will
increase the amount of delay time to a maximum of 9 hours. To cancel Delay Start, press the Reset button. To
start the delay period press Start. The delay time will start to count down in the display window. To cancel Delay
Start once the countdown has started, de-power the machine by opening the dryer door.
NEVER SWITCH THE DRYER OFF AND LEAVE A HOT LOAD IN THE DRUM DUE TO THE RISK
OF FIRE.
ALWAYS CLEAN THE FILTER AFTER EACH USE. Failure to do so could cause the safety cut-out to
operate.
- Pull the filter upwards and away from the appliance.
- Remove any threads or fluff by hand or with a soft brush.
- Slide the filter back.
- Wash the filter occasionally in detergent solution using a soft brush
to remove small particles.
- If your filter becomes damaged, replace it to ensure no damage is
caused to the dryer.