INSTRUCTIONS FOR USE TUMBLE DRYERS GB IMPORTANT PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE USING THIS APPLIANCE. KEEP THEM IN A SAFE PLACE FOR FUTURE REFERENCE.
Read the instructions INSTALLATION Position the tumble dryer so that the plug remains accessible after installation. Do not block the vent at the front or base of the dryer, as this will impair the working of the machine. This appliance must not be installed behind a lockable door, a sliding door or a door with hinges on the opposite side to that of the tumble dryer.
FINAL INSTALLATION Push the filter into its operating position as shown in the diagram. If you wish to change the side on which your door opens, see the instructions on the back page. Remove any dust by wiping the drum and door with a damp cloth. Any initial smell of burning will be caused by dust on the heater and will quickly disappear. THE CONTROLS – (control panel styles may vary) A. HEAT SWITCH Select the required heat setting based on the recommendations on the control panel. B.
To avoid the need to iron easycare polyester/cotton items it is .better to only dry small loads (i.e. half fill drum) It is better to dry small and large articles together. Fabric softeners, or similar products, should be used as specified by the fabric softener instructions. Do not overload the dryer or dry large bulky items such as duvets or sleeping bags as it is important that the airflow through the dryer is not obstructed.
- Pull the filter upwards and away from the appliance. - Remove any threads or fluff by hand or with a soft brush. - Slide the filter back. - Wash the filter occasionally in detergent solution using a soft brush to remove small particles. - If your filter becomes damaged, replace it to ensure no damage is caused to the dryer. THE CONDENSER The condenser and ducting should be cleaned monthly or more frequently if the dryer is in constant use. See “CLEANING THE CONDENSER” below.
This cut-out only operates if the airflow is severely restricted so make sure the filter is clean and that all other restrictions are removed before re-starting. If the cut-out continues to operate after checking the above points, you should contact your service agent. Check that the machine has the correct weight load in the drum before stating the appliance. If your machine does not work check the following before calling a service engineer:- Check that there is a supply of electricity.
–The rear of the dryer gets quite hot during use. Position the dryer so that the back is not accessible while in operation, but ensure that the sides have a space available to allow airflow. –The special mains cable and plug assembly must only be replaced with a genuine part from the manufacturer or our appointed service agent. It is important to clean fluff from the window of the dryer and around the door seal after each drying cycle. Failure to do so could result in water leaking.
Manufactured by Crosslee plc, Lightcliffe Factory, Halifax,West Yorkshire, HX3 8DE 4213 094 67462