Operation Manual

Assembly of the fan
1. Remove the blade cap from the motor shaft and remove the guard lock nut
from the motor body.
2. Fit the rear guard to the motor body, by positioning on the location pins.
Secure the guard to the motor body with the guard lock nut.
3. Push the fan blade onto the motor shaft by matching the slots on the base of
the fan blade with the shaft pin. Secure the blade with the blade cap, turning
it in an anti-clockwise direction. Check that the fan blade rotates freely by
turning it with your hand.
4. Open the securing clip at the bottom of the front guard and loosen the clip
screw. Position the top clip on the uppermost part of the rear guard. Push
the top clip down and press rim of the front guard onto the rear guard.
Close the bottom clip and tighten the screw.
Operations
1.
3-Step Speed Control
OFF 0
LOW 1
MEDIUM 2
HIGH 3