SAFETY DATA SHEET WL0003070 Section 1. Identification Product name : WHITE LIGHTNING® 3006™ ULTRA All Purpose Elastomeric Sealant Almond : WL0003070 Product code Other means of : Not available. identification Product type : Liquid. Relevant identified uses of the substance or mixture and uses advised against Paint or paint related material. Manufacturer : White Lightning Products 101 W.
Section 2. Hazards identification Precautionary statements General Prevention Response Storage Disposal Supplemental label elements : Read label before use. Keep out of reach of children. If medical advice is needed, have product container or label at hand. : Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves. Wear eye or face protection. Wear protective clothing. Use only outdoors or in a well-ventilated area.
Section 4. First aid measures Description of necessary first aid measures Eye contact : Immediately flush eyes with plenty of water, occasionally lifting the upper and lower eyelids. Check for and remove any contact lenses. Continue to rinse for at least 10 minutes. Get medical attention. : Remove victim to fresh air and keep at rest in a position comfortable for breathing. If it is suspected that fumes are still present, the rescuer should wear an appropriate mask or self-contained breathing apparatus.
Section 4. First aid measures Protection of first-aiders : No action shall be taken involving any personal risk or without suitable training. If it is suspected that fumes are still present, the rescuer should wear an appropriate mask or self-contained breathing apparatus. It may be dangerous to the person providing aid to give mouth-to-mouth resuscitation. Wash contaminated clothing thoroughly with water before removing it, or wear gloves. See toxicological information (Section 11) Section 5.
Section 6. Accidental release measures Large spill : Stop leak if without risk. Move containers from spill area. Approach release from upwind. Prevent entry into sewers, water courses, basements or confined areas. Wash spillages into an effluent treatment plant or proceed as follows. Contain and collect spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in container for disposal according to local regulations (see Section 13).
Section 8. Exposure controls/personal protection Crystalline Silica, respirable powder 14808-60-7 OSHA PEL Z3 (United States, 6/2016). TWA: 250 mppcf / (%SiO2+5) 8 hours. Form: Respirable TWA: 10 mg/m³ / (%SiO2+2) 8 hours. Form: Respirable OSHA PEL (United States, 5/2018). TWA: 50 µg/m³ 8 hours. Form: Respirable dust ACGIH TLV (United States, 3/2019). TWA: 0.025 mg/m³ 8 hours. Form: Respirable fraction NIOSH REL (United States, 10/2016). TWA: 0.05 mg/m³ 10 hours.
Section 8. Exposure controls/personal protection TWAEV: 0.1 mg/m³ 8 hours. Form: Respirable dust. CA Ontario Provincial (Canada, 1/2018). TWA: 0.1 mg/m³ 8 hours. Form: Respirable fraction. CA Alberta Provincial (Canada, 6/2018). 8 hrs OEL: 0.025 mg/m³ 8 hours. Form: Respirable particulate CA Saskatchewan Provincial (Canada, 7/2013). TWA: 0.05 mg/m³ 8 hours.
Section 8. Exposure controls/personal protection Respiratory protection : Based on the hazard and potential for exposure, select a respirator that meets the appropriate standard or certification. Respirators must be used according to a respiratory protection program to ensure proper fitting, training, and other important aspects of use. Section 9. Physical and chemical properties Appearance Physical state : Liquid. Color : Not available. Odor : Not available. : Not available.
Section 11.
Section 11. Toxicological information Information on the likely routes of exposure : Not available. Potential acute health effects Eye contact : Causes serious eye irritation. Inhalation : May cause respiratory irritation. Skin contact : Causes skin irritation. Ingestion : No known significant effects or critical hazards.
Section 12.
Section 14. Transport information Transport hazard class(es) - - - - - Packing group - - - - - Environmental hazards No. No. No. No. No. Additional information - - - - - Special precautions for user : Multi-modal shipping descriptions are provided for informational purposes and do not consider container sizes. The presence of a shipping description for a particular mode of transport (sea, air, etc.), does not indicate that the product is packaged suitably for that mode of transport.
Section 16. Other information Hazardous Material Information System (U.S.A.) * Health 2 Flammability 0 Physical hazards 0 The customer is responsible for determining the PPE code for this material. For more information on HMIS® Personal Protective Equipment (PPE) codes, consult the HMIS® Implementation Manual. Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4 representing significant hazards or risks.
Section 16. Other information responsible to determine the conditions necessary for the safe use of this product. The customer/buyer/user should not use the product for any purpose other than the purpose shown in the applicable section of this SDS without first referring to the supplier and obtaining written handling instructions. Due to the proliferation of sources for information such as manufacturer-specific SDS, the manufacturer cannot be responsible for SDSs obtained from any other source.
