User's Manual

23340-4-0608Page 30
Installing Vent Components (Figure 44)
Begin the vent system installation by installing the first Simpson Duravent
component, 90° elbow to the starting collars or straight pipe on the top of
the appliance, then the straight pipe length and then horizontal or vertical
termination kit.
NOTE: All outer connection joints must be sealed with aluminum
tape, screws or silicone sealant rated above 300°F/149°C. The inner
flue joints do not require any sealant.
Simpson Duravent vent system components lock into place by sliding the
concentric pipe section with four (4) equally spaced interior beads onto
the appliance collar or previously installed component end with four (4)
equally spaced indented sections. When the internal beads of each starting
outer pipe line up, rotate pipe section clockwise 90° (approximately 3
inches). The vent pipe is now locked together.
Continue adding components per the pre-planned vent system configuration.
Be certain that each succeeding vent component is securely fitted and
locked into the preceding component in the vent system.
Figure 44
WALL THIMBLE
(MAXIMUM
OF
THREE 90 ELBOWS)
(MAXIMUM OF
TWO 90 ELBOWS)
Special venting components (Simpson Duravent)
See Empire Comfort Systems Retail Price List for Simpson Duravent part numbers and
pricing.
Special DV Vent Kits
Available from Empire Comfort Systems, Inc. dealers.
DVVK-4VP
(DVVK-4V)
Direct-Vent Fireplace Vent Kit - Vertical, Includes SD-991, SD-953,
and SD-943
DVVK-4TP
(DVVK-4T)
Direct-Vent Fireplace Vent Kit for Top Vent, Thru-the-wall, 8 to 11 inch
wall thickness, Includes SD-911, SD-985, SD-990 and SD-942
DVVK-4RP
(DVVK-4R)
Direct-Vent Fireplace Vent Kit for Rear Vent, 5 to 7 inch wall thickness,
(standard thru-the-wall venting) includes SD-908, SD-985 and SD-
942
DVVK-4RE
Direct-Vent Fireplace Vent Kit For Rear Vent, Thru-the-wall for 5 to
13 3/4 inch wall thickness.
DVVK-4TSP
(DVVK-4TS)
Direct-Vent Fireplace Vent Kit for Top Vent, Thru-the-wall, 5 to 7 inch
wall thickness, Includes SD908, SD-985, SD-990 and SD-942
DVVK-4FV Vertical Flex Vent Kit 4" x 7"
VIB6A Vertical Inlet Baffle Kit For 6 5/8" dia.
VIB7A Vertical Inlet Baffle Kit For 7" dia.
VENT SYSTEM IDENTIFICATION