Zero Turn Riding Mower Operator's Manual

23
REPLACING THE HEAD LAMP BULB
1. Remove the ignition key from ignition switch.
2. Detach the bottom of the rubber boot cover on the drive handles.
3. Slide the boot cover all the way up (toward the drive handles) to access the drive handle bolts.
4. Remove both bolts securing the drive handles.
5. Remove the drive handles and the rubber boot.
6. Remove the four bolts securing the retaining plate to the control tower cover.
7. Pull up on the control tower cover and slide up and over the control tower.
8. Locate the rear of the light fixture where the wire attaches. (See Figure 18)
Figure 18
9. Remove the wire from the light bulb assembly.
10. Squeeze the tab on the connector that attaches the wire to the light bulb assembly.
11. Pull the wire from the light bulb assembly.
12. Turn the light bulb assembly counterclockwise to release it from the light fixture.
13. Carefully pull the light bulb out of the light fixture.
14. Insert the replacement light bulb into the light fixture.
15. Turn the light bulb assembly clockwise until it locks into place.
16. Carefully insert the connector into the light bulb assembly.
17. Replace the control tower cover and drive handle assemblies.
CHANGING THE FUSE
Always use the same rated fuse when replacing.
1. Open the engine compartment.
2. Locate the fuse. It can be found on the wiring harness located in a protective cover between the engine and
the battery.
3. Remove the old fuse and replace with the same rated fuse.
BATTERY MAINTENANCE
All batteries are sealed and maintenance free.
CHARGING THE BATTERY
The engine is equipped with an alternator which charges the battery when tractor is operated. Under normal
conditions, the battery only needs to be charged, during and after off-season storage.
Light Reflector
Light Bulb
Connector
Look Here