Owner's Manual

Toassignprioritytoasensor,press
PROGRAM _ and _ to
select the period, then press the
VACATION key. On the display in
place of OCCU or UNOC the priority
of the sensor and the sensor identifica-
tion will appear. Press the VACATION
key to step through the sensors that are
installed and enabled L (local), A, B or
C. Only sensors that are installed and
enabled will be listed. When the sensor
you wish to change is displayed, press
the DAYLIGHT SAVING TIME key
to change the priority (AVG, HI or
LO). AVG is the default setting. A
setting of HI gives a sensor more
importance and a setting of LO gives
less importance.
Daylight Savings Time Button.
One button adjustment allows you to
change your thermostat clock between
Standard Time and Daylight Savings
Time. Simply push the DAYLIGHT
SAVINGS TIME key to advance the
time forward one hour in the Spring. In
the Fall press the DAYLIGHT
SAVINGS TIME key twice to tall
back an hour. If you push it three times
in a row (in less than 30 seconds) it
will return to the original time setting.
After clock adjustment, press PRO-
GRAM _ to resume your normal
program.
Large Lighted Liquid Crystal
Display (LCD).
The large numbers and letters on your
LCD screen make it easy to see. In low
light conditions, press the button on
top of the thermostat and the display
will light up for three seconds. For ten
minutes after pressing the light button,
pressing any other button will light the
display for ten seconds.
The thermostat display alternately
shows the current time and the current
temperature on the left side. The
20
display also shows the temperature you
have programmed or set on the right
side of your screen.
Arm Chair Programming.
The thermostat uses 24 VAC power
supplied by the system for normal
operation. The electrolytic capacitor
allows you the added convenience of
programming the thermostat even
when not attached to the wallplate,
Attach the thermostat to the wallplate
and allow the capacitor to charge for at
least one hour. After the capacitor is
charged you will have approximately
one hour after removing the thermostat
from the wallplate to configure and
program the thermostat.
Thermostat Startup After Total
Power Loss.
On installation, or when power is
restored after a total power loss to the
thermostat, your thermostat will