Owner's Guide

Assembly
1. Remove all parts from the shipping carton and check assembly
diagram to ensure all parts are present.
2. Install black rubber washers on ber lower rod; attach search coil
to lower ber rod. Use only the nonmetallic washers, ber bolt,
and ber thumbnut provided to secure search coil loop to the
lower ber rod.
3. Insert lower ber rod into center rod so that the spring buttons
line up with one of the length-adjustment holes in the center rod.
Turn the camlock to eliminate any slack.
4. Insert the center extension rod into the hand-grip section. Turn
the camlock to eliminate any slack.
5. Wind the search coil cable around the rods, rst revolution over
the top of the rod, all the way to the display pod. Plug the cable
into the connector on the back of the display. When looking at the
back of the display, it is the connector on the right. Tighten the
retainer ring securely.
Fiber Bolt & Thumbnut
Search Coil
Non-metallic
Washers
Fiber Rod
Center Rod
Search Coil
Cable
Camlock
2