Service manual
Page 20
P/N 316439220
Photo B
↑
↑
LIFT DOOR HINGE ARMS OVER ROLLER PINS
To Replace Oven Door:
1. Firmly grasp both sides of oven door along the door
sides (Do not use the oven door handle).
2. Holding the oven door at the same angle as the re-
moval position, seat the hook of the hinge arm over the
roller pins located on each side of the oven door frame.
3. Fully open the oven door (horizontal with fl oor).
4. Push the door hinge locks up towards and into the
oven frame on both left and right oven door hinges to
the locked position.
5. Close the oven door.
Door Hinge Replacement
Disassemble Door
1. Place the door with the handle side down on a
protected work surface. The handle should hang
off the edge of the bench or table.
2. Remove the bottom screws that secure the in-
ner liner to the outer door panel. (Fig. 3)
3. Remove the two handle mounting screws and
remove the door handle. (Fig. 4)
Bottom Screws
Fig. 3
Fig. 4
Handle Mounting Screws
Hinge Mounting Screws
Fig. 5
4. Carefully separate the inner door panel and
hinge assembly from the outer panel. Place the
assembly with the hinge side hanging slightly off
the work surface.
5. Remove the two hinge mounting screws and
lower the hinge assembly away from the inner
door panel. (Fig. 5 & Fig. 6).
6. Install new hinge and reverse the steps to reas-
semble the oven door.
Fig. 6
TIP: TO EASE INSTALLATION OF NEW HINGE, INSTALL AND REMOVE THE SELF TAPPING SCREWS INTO THE SCREW HOLES IN THE NEW HINGE .
THIS WILL PRE-CUT THREADS INTO THE HINGE AND ALLOW FOR EASIER STARTING OF THE SCREWS ONCE THE HINGE IS IN POSITION.
When replacing the door hinges you must ensure that the hinge lock lever is in the fully engaged position in
order to reinstall the oven door on the range. The hinge is replaced as a complete assembly only.
HINGE LOCK ENGAGED
HINGE LOCK
DISENGAGED
The same hinge assembly design is used for many different oven doors but with different door spring pull
weights. The color of the door spring determines the pull weight. Make sure that the replacement hinge spring
color is correct for the model that is being serviced.