Installation Guide

© 2005 WHITEHALL PRODUCTS Visit our Web Site at: www.whitehallproducts.com AW-337
HOSE STATION ASSEMBLY INSTRUCTIONS
A
B
C
D
The Whitehall Hose Station allows access to a faucet where shrubs or delicate flowers would
prevent the use of the wall faucet. The Hose Station also provides an auxiliary location for
your faucet. Simply install and turn the wall faucet on, using the hose station as the new
on/off water valve.
HOSE HOLDER CONSISTS OF:
(A) 1 - DECORATIVE FACE
(B) 3 - MACHINE SCREWS
(C) 1 - T-PLATE
(D) 3 - SUPPORT TUBES
ASSEMBLY OF HOSE HOLDER:
1. Place decorative face (A) front side down.
2. Place machine screws (B) through indicated holes on the t-plate (C).
3. Place one support tube (D) over one machine screw (B) and place over decorative face (A).
Align (A) & (B) so that the machine screw goes through the support tube and threads into the
corresponding hole on the back side of (A).
4. Lightly screw together (do not tighten yet).
5. Repeat steps 3 - 4 with the remaining support tubes (D).
6. Tighten all screws until snug with screwdriver.
7. Mount onto hose station post with keyhole slots on t-plate (C). See reverse side for post installation.
Rev. 5/06
HOSE STATION POST CONSISTS OF:
(A) 1 - POST (FAUCET PRE-ASSEMBLED)
(B) 2 - BOLTS
(C) 1 - HOSE HOLDER (See reverse side for assembly instructions)
(D) 2 - WASHERS
(E) 2 - ACORN NUTS
(F) 1 - 10’ LEADER HOSE
(G) 1 - SCREW
(H) 1 - HOSE CLIP
(I) 1 - FINIAL (May vary per model)
I
E
D
C
B
A
G
H
F
ASSEMBLY/INSTALLATION OF HOSE STATION:
1. Assemble Hose Holder (C)
(See reverse side for assembly instructions).
2. Use Bolts (B), Washers (D) and Acorn Nuts (E) to attach
Hose Holder (C) to Post(A) (See diagram).
3. Attach Hose Clip (H) on back side of Post (A)
with screw (G) provided.
4. Attach Finial (I) to Post (A) by placing the finial on top of the
post and lightly tapping down with a rubber mallet until finial
sets tight against the post.
5. Create hole in desired location of yard 16” deep.
6. Stand Hose Station in the hole and backfill with soil.
7. Check for vertical and pack backfilled soil firmly around post.
8. Connect Hose (F) to house faucet and hose station fitting.
9. Clip Hose into place (H) at back of post.