Installation Guide

CAPITOL MAILBOX
©2020 Whitehall Products, LLC Customer Service: 800.728.2164 www.whitehallproducts.com AW-1072
Need additional assistance? If you have questions about your mailbox you may call Whitehall Products Customer Service: 800.728.2164
B
C
D
A
Personalized Door and Side Plaque Installation
Parts Included:
Lay down a soft clean cloth on a flat surface. Place Capitol
Mailbox (A) on its side and one (1) address sign (B) face
down. With a soft cloth, wipe backside of the plaque and
within the mailbox's plaque frame to ensure proper tape
adhesion.
Without removing the adhesive backing, place four (4) of
the provided Adhesive Tape Squares (C) within the corners
of the plaque frame (FIG. 1A) approx. 1/4"-1/2" from each
border edge. Be sure to give each square enough space to
avoid overlap or overhang (FIG. 1B).
Once evenly spaced, peel off one (1) plastic backer of each
adhesive tape square one by one and replace EXACTLY with
the sticky side down. TAPE BONDS IMMEDIATELY. Press
firmly for 15 seconds to FULLY activate adhesive. Repeat for
each tape square.
Peel off the remaining plastic backers. Locate clean address
sign (B) and ensure sign has upright orientation before
installation. The adhesive bond immediately and cannot
be repositioned. With the Mailbox (A) still on its side, align
the address sign (B) within the raised border. Slowly set the
plaque in its place. Press firmly for 15 seconds over each
tape location to FULLY activate adhesive.
Continue with steps 1-4 for remaining address sign (B) and
Door Sign (C).
Enjoy your new personalized Capitol Mailbox!
1)
2)
3)
4)
5)
6)
Instructions:
Capitol Mailbox
Address Sign - 2 (optional)
Door Sign (optional)
2” x 2” Adhesive Tape Squares
A)
B)
C)
D)
Place tape within raised boarder 1/4”
FIG.1A
FIG.1B