Installation Guide

Wall Plaque Mounting Instructions

Parts Included:

A) Address Plaque

B) #8 x 1.0-in. Wall Screws

You may need the following (not included):

1) Pencil 4) 1/8” Drill Bit 7) Masonry Anchors

2) Level 5) Hammer 8) Masonry bit for Anchors

3) Drill 6) Phillips Screw Driver 9) Longer #8 or #10 Screws

Masonry Recommendations:

When attaching your address plaque to brick, block, or cultured/faux stone walls it will be necessary to purchase the

appropriate anchors for your mounting surface. For most brick or block applications, a standard plastic wall anchor

for a #8 screw can be used in conjunction with the provided #8 screws. An appropriately sized masonry bit will also be

needed to drill the holes for the anchors.

Cleaning Instructions:

Your new address plaque is made of hand-cast aluminum with tough Alumi-Shield™ nishes to withstand the

environment and should retain its appearance for many years. However chemicals, solvents and salts can harm the

nish. It is important to clean the plaque of any harmful elements including salt deposits from salt air climates or salt

treated roads and walkways. To clean this product, use a non-abrasive detergent and water with a cloth, sponge, or soft

brush. Note: the simulated metal nishes cannot be brightened by polishing.

Need Additional Help or Assistance?

If you have any issues or questions about your address plaque or if you need any further assistance in the attachment

process, you may call Whitehall Products Customer Service at 800.728.2164

How to attach to your home:

1) Place your new address plaque (A) up

against the wall in the desired location,

check for level and mark the wall in the

mounting hole locations.

2) If the mounting surface is wood or

wood covered with siding, use a drill and

1/8” drill bit to drill a pilot hole at each

hole location. If the mounting surface is

masonry please see recommendations

below.

3) Using the wall screws (B) provided and

screw driver, secure the address plaque (A)

to the wall. Note: if the house siding is

too thick or layered over foam board

insulation, longer #8 screws (not provided)

may be required.

ADDRESS

PLAQUE

PAGE 1
Wa l l P l a q u e M o u n t i n g I n s t r u c t i o n s Parts Included: You may need the following (not included): A) Address Plaque B) #8 x 1.0-in. Wall Screws 1) Pencil 2) Level 3) Drill 4) 1/8” Drill Bit 5) Hammer 6) Phillips Screw Driver 7) Masonry Anchors 8) Masonry bit for Anchors 9) Longer #8 or #10 Screws How to attach to your home: 1) Place your new address plaque (A) up against the wall in the desired location, check for level and mark the wall in the mounting hole locations.