Installation Guide

WAT RHAUS
Thank you for selecting this product!
IMPORTANT NOTICES: For easy installation, please read all
the instructions completely before beginning. Before installing
this product, make sure that water lines are properly ushed
and cleared to avoid blockage.
WARNING: Assembly by a professional plumber is required.
Clean all dirt and debris
from supply valves
before proceeding with
installation. If you are
replacing an existing
faucet, remove the faucet
from the sink and clean
the surface thoroughly.
Installation Guide
WHS0311SB
Drill a Ø1-3/8" to Ø1-
1/2" hole (2) in sink (1).
Install the shank (3)
into the faucet body (4).
And screw them firmly.
Then put O-ring (5) into
base groove and insert
through the hole(2).
Adjust the faucet to the
right position and put on
the rubber gasket (7) and
the metal washer (8) and
lock nut (9), tighten using
a wrench.
1. Always turn off water and relieve pressure before working on your faucet.
1. Clean the faucet with mild soap and water, then wipe the faucet dry with soft cloths.
2. Do not use cleaners which contain acids, harsh chemicals, or abrasives.
3. Repeat steps 1-2 whenever necessary.
Connect the flexible hoses
to the water supply valves
(left to hot water and right
to cold). Make sure flexible
hoses are securely fastened
before turning on valve.
27
1
/
4
8
1
/
2
10
1
/
2
4
1
/
2
Check all joints to make
sure it's connected properly.
Then turn on the water to
check the bottom handle
for leakage.
Pull the handle upward to
turn on the faucet, downward
to turn off. Face the spout,
move the handle to the left to
control hot water and to the
right to control cold water.
Aerator is dirty, worn or
misfitted.
Worn cartridge. Replace cartridge.
5 6
Open
Open
4
5 6
Open
Hot
Cold
4
2 3
3
4
6
5
2
1
7
8
9
1
[P] 1.800.527.6900 WhitehausCollection.com [F] 1.800.694.4837
1 2 3
TROUBLESHOOTING