Operation Manual

De va atw as serd e ur ni et o pene n ti jde ns ge brui k.
PREMISE:
1. You can modify the washing program when the dishwasher just runs for a short time. Otherwise, the detergent may
have already been released, and the appliance may have already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the section entitled " Loading the Detergent " ).
2. Press start/reset button more than 3 seconds to cancel the current program, then you can change the program to the
desired cycle setting (see the section entitled " Starting a wash cycle. . . ").
NOTE:
If you open the door when washing, the machine will pause. The buzzer will mooing every minute unless
you close the door. Close the doorand press the start/reset button, the machine will keep on working
after 10 seconds.
Turning on the Appliance
Starting a cycle wash
1 Draw out the lower and upper basket, load the dishes and push them back.
It is commended That loading the lower basket first, than the upper one (see
the section entitled “"Loading the Dishwasher ”).
2 Pour in the detergent (see the section e`ntitled Salt, Detergentand RinseAid”).
3 Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ,
the specification of the socket is 10 A 250 VAC. Make sure that the water supply is
turned on to full pressure.
4 Close the door, press the ON/OFF button, and the ON/OFF light will turn on.
Turn the Washing Program Knob to select a desired Wash cycle, then press the start/reset
button, 10 Seconds later, the machine will work.