User guide

Scan to email
Use the product control panel to scan a file directly to an email address. The scanned file is sent to the
address as an email message attachment.
NOTE: In order to use this feature, the product must be connected to a network and the scan feature
must be configured using the HP Embedded Web Server.
1. Load the document onto the scanner glass or into the document feeder.
2. From the Home screen on the product control panel, touch the Scan button.
3. Touch the Scan to E-mail item.
4. Touch the Send an E-mail item.
5. Select the From address that you want to use. This is also known as an “outgoing email profile.”
NOTE: If the PIN feature has been set up, enter the PIN and touch the OK button. However, a
PIN is not required to use this feature.
6. Touch the To button and pick the address or group to which you want to send the file. Touch the
Done button when finished.
7. Touch the Subject button if you would like to add a subject line
8. Touch the Next button.
9. The control panel screen displays the scan settings.
●
If you want to change any of the settings, touch the Settings button, and then change the
settings.
●
If the settings are correct, go to the next step.
10. Touch the Scan button to start the scan job.
ENWW
Scan to email
115