Manualshelf

Instructions / Assembly

ManualsBrandsWhitmor ManualsStorage & OrganizationSupreme Garment Collection 60 in. x 64 in. Extra Wide Clothes Closet
1
6013-167 Clothes Closet ©2006 Whitmor
B 5 ea
30.75” Frame tube
I 1 ea
Cover
H 2 ea
Bottom Panel
C 5 ea
30.75” Male frame tube
F 1 ea
30.75” Clothes rod
D 6 ea
31.5” Male frame tube
G 1 ea
30.75” Male clothes rod
A2 2 ea
Center support
Part Reference
A1
A2
B
C
D
E
F
G
H
I
F6044
F6045
F6046
F6047
F6048
F6064
F6049
F6050
F6051
F6052
Assembly
Time:
Less than
1 hour.
This product's intended
use is for storing clothes.
Tools Needed:
No tools required.
MADE IN CHINA
For missing parts or assistance:
Whitmor/Customer Service Department
P.O. Box 28 • 17539 Hwy 64 • Earle, AR • 72331
1-888-944-8667
customer_service@whitmor.com
Printed in China
STEP 1. To assemble the
lower frame, insert three
frame tubes (B) into one
corner support (A1). Place
center support (A2) onto
frame tube ends. Insert
three male frame tubes (C)
into center support where
frame tubes intersect.
Place another corner
support (A1) onto the end.
STEP 2. Insert six male frame
tubes (D) into lower frame
followed by six frame tubes (E).
STEP 4. Place complete upper
frame assembly from step 3 on
top of closet.
STEP 5. Place 2 bottom panels
(H) in the bottom of the closet.
Unzip zipper on cover (I) and
carefully place over top of closet
and slide down, holding onto the
top corners to prevent snagging.
Make sure to pull all corners down
evenly.
E 6 ea
31.38” Frame tube
A1 4 ea
Corner support
A1
A1
Note: All metal parts must be
inserted firmly and completely into
the plastic parts.
Note: Closet rods (F & G) are wider
in diameter than frame tubes (B & C)
and are inserted into the larger lower
center holes on (A1 & A2).
Note: Although your
clothes closet can be
assembled by one person,
it is recommended that two
people install the cover.
I
A2
B
B
B
C
C
C
D
D
E
E
A1
A1
A2
B
B
C
C
F
G
STEP 3. To assemble top of
frame, insert two frame tubes (B)
and the clothes rod (F) into one
corner support (A1). Insert center
support (A2) onto the tubes. Insert
two male frame tubes (C) and the
male clothes rod (G) into center
support where frame tubes
intersect. Place another corner
support (A1) onto the end.
Note: The middle tubes (B&C) go
into the smaller upper center holes
on (A1 & A2).
H
Rev#1 6.1.06

Summary of content (1 pages)