Instructions / Assembly

NOTE: part D has a plastic cap on one end
NOTE: part E has a small, threaded hole on one end
NOTE:
2 of the wheels
have locking
mechanisms
A 16 ea
Sleeve
B 4 ea
Wheel
C 1 ea
Wrench
G 2 ea
Shelf
H 2 ea
Hanging rod
bracket
J 2 ea
Screw
D 4 ea
Top pole
F 4 ea
Threaded
connector
E 4 ea
Bottom pole
I 1 ea
Hanging rod
6058-90 Supreme Garment Rack ©2013 Whitmor, Inc.
STEP 1. Connect part (D) and part (E) by
screwing part (F) into the open end of one of the
chrome poles (there is a small ridge in the
middle of part (F) at the center). Screw the other
chrome pole into the threaded connector (F) until
it meets the other chrome pole. Repeat for
remaining poles.
STEP 2. Start at the bottom (the end
with the small threaded hole, see
diagram above), snap two plastic
sleeves (A) onto chrome poles at
desired intervals. The sleeves are
marked with a directional arrow to
show proper placement. Use grooves
on poles to ensure even shelf
placement among the four poles.
NOTE: Place only enough sleeves to
assemble bottom shelf. This step will
be repeated after bottom shelf is in
place.
This product's intended use
is for storing clothes.
Assembly Time:
Less than 30 minutes.
Tools Needed: No additional tools
required. A wrench (C) is provided.
D
F
D E
D E
A
D
STEP 3.
Slide chrome
poles with plastic cap on
top through shelf corners
until shelf rests firmly on
sleeves. Push or gently
tap the shelf down at
corners to level shelf.
Repeat step 2 and
position top shelf.
Page 1