Instructions / Assembly

6060-3436 Supreme Small 3 Tier Shelving ©2013 Whitmor, Inc.
A 24 ea
Sleeve
D 4 ea
Upper pole
E 4 ea
Lower pole
B 4 ea
Foot
C 3 ea
Shelf
Assembly
Time:
Less than
30 minutes.
Tools Needed:
No tools required.
STEP 1. Connect upper pole (D) to lower pole (E) by
threading connector (F) into open end of the poles (there is
a small ridge in the middle of part (F) to gauge the
distance). Screw foot (B) into assembled pole at small
threaded end. Repeat step 1 for remaining poles.
STEP 2. Starting at the bottom
(the end with the small threaded
hole and foot), snap two sleeves
(A) onto poles at desired intervals.
The sleeves are marked with a
directional arrow to show proper
placement. Use grooves on poles
to ensure even shelf placement
among the four poles. NOTE: Place
only enough sleeves to assemble
bottom shelf. This step will be
repeated for each additional shelf.
STEP 3. Slide poles
with plastic cap on top
through shelf corners
until shelf rests firmly on
sleeves. Push or gently
tap the shelf down at
corners to level shelf.
Repeat steps 2 and 3 for
each additional shelf.
Turn feet (B) to level unit.
NOTE: part D is shorter.
NOTE: part E is longer.
E
D
D F
D
D E
E
A
Part Reference
A
B
C
D
E
F
F7052
F7053
F7054
F7055
F7056
F7057
B
This product's intended
use is for added shelving
space anywhere in the
home or office. 200 lb.
shelf capacity when
weight is distributed
evenly across shelf.
F 4 ea
Threaded connector
(may be already attached
to D or E)
TEN YEAR LIMITED WARRANTY
All Supreme wire products distributed by Whitmor, Inc. (the "Company") are warranted to the original purchaser at the time of purchase and for ten (10) years after the purchase date ("warranty term"). The Company warrants to
you, the original purchaser, that our Supreme wire products and all metal or plastic parts and components are free of defects in material or workmanship during the warranty term. The word "defects" as used in this limited
warranty is defined as any imperfections which impair the use of the Supreme wire product. This limited warranty is expressly limited to the replacement or repair of metal or plastic parts and components (in the Company's
discretion) and the Company will have a reasonable amount of time to remedy said defect. This limited warranty only applies under conditions of normal use. This limited warranty does not cover defects caused by improper
assembly or disassembly, defects occurring after purchase due to intentional damage, product modifications, exposure to the elements (including, but not limited to, wet environments), accidents, misuse, abuse or negligence and
labor or assembly costs.
THE COMPANY DISCLAIMS ALL OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING, WITHOUT LIMITATION, ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, EXCEPT TO THE EXTENT
THAT ANY WARRANTIES IMPLIED BY LAW CANNOT BE VALIDLY WAIVED. NO ORAL OR WRITTEN INFORMATION OR ADVICE GIVEN BY THE COMPANY, ITS DISTRIBUTORS, DEALERS, AGENTS OR EMPLOYEES, SHALL CREATE ANOTHER
WARRANTY OR MODIFY THIS LIMITED WARRANTY. THIS LIMITED WARRANTY STATES THE COMPANY'S ENTIRE LIABILITY AND YOUR EXCLUSIVE REMEDY AGAINST THE COMPANY FOR ANY FAILURE OF THE SUPREME WIRE PRODUCT
TO OPERATE PROPERLY. NEITHER THE COMPANY NOR ANYONE ELSE INVOLVED IN THE DEVELOPMENT, PRODUCTION, OR DELIVERY OF THIS SUPREME WIRE PRODUCT SHALL BE LIABLE FOR ANY INDIRECT, INCIDENTAL, SPECIAL,
CONSEQUENTIAL, EXEMPLARY, OR PUNITIVE DAMAGES, INCLUDING LOST PROFITS, ARISING FROM THE USE OF OR INABILITY TO USE THE PRODUCT, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT
ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. This Warranty gives you specific legal rights and you may also have
other rights, which vary from State to State.
The Limited Warranty set forth above is provided on products purchased in and used in the United States, and is only in effect with valid proof of purchase (bill of sale) presented or shipped (shipping cost prepaid) to the Company
within the United States at the address above. For Customer service call 1 [phone] or visit us on the web at www.whitmor.com.
8680 Swinnea Road • Suite 103 • Southaven, MS • 38671
NEED HELP? For help with assembly, or if you are missing a part,
please call Whitmor’s Customer Service Department, 1-888-944-8667
between 8 a.m. and 4:30 p.m. (Central Standard Time) Monday
through Friday. Or email: [e-mail]. Visit us
online at www.whitmor.com
Rev.1 | 10.01.13 Printed in China