Assembly Instructions

B 2 ea

Foot

C 8 ea

Horizontal pole

A 4 ea

Side frame

This product's intended use

is for storing shoes.

Assembly Time:

Less than 15 minutes.

Tools Needed: No tools required.

MADE IN CHINA

For missing parts or assistance:

Whitmor/Customer Service Department

P.O. Box 28 • 17539 Hwy 64 • Earle, AR • 72331

1-888-944-8667

customer_service@whitmor.com

Part Reference

F6075

F6076

F6077

STEP 1. Place two side frames (A) on a flat hard surface. Snap each side frame together. Insert 8 horizontal poles (C)

into holes in side frames at desired locations. Snap foot (B) on bottom end of side frame.

STEP 2. Place five remaining two frames (A) on a flat hard surface. Snap each side frame together. Place assembled

side frames onto top of poles aligning poles with the holes in side frames. Tap firmly until poles are seated into holes.

Snap foot (B) on bottom end of side frame.

NOTE: Tube placement is optional. Decide how you want to set up your shoe stand before inserting the poles.

Some poles can be left out of the middle for high top shoes and boots. Most shoes work best with the back tube

higher than the front tube. Shown here is our recommended placement for most uses.

Printed in China

C C C C

A A

STEP 3. Turn assembled shoe tower

upright. Assembly is now complete.

Rev#1 4.22.08