Assembly Instructions

ManualsBrandsWhitmor ManualsCloset OrganizersModern Industrial Entryway Organizer

Page 1

Tools Needed:

Phillips screwdriver & hammer

are needed for wall mounting

A 2 ea

Side frames

B 2 ea

Wire shelves

E 2 ea

Middle vertical

tubes

F 2 ea

Upper vertical

tubes

H 2 ea

Horizontal posts

M 8 ea

Hooks

L 4 ea

Feet

N 1 ea

Hex

wrench

O 1 ea

Safety

bracket

P 1 ea

Wall

screw

Q 1 ea

Wall

anchor

J 6 ea

Medium hex screws

K 6 ea

Short hex

screws

I 20 ea

Long hex

screws

G 1 ea

Top

C 2 ea

Horizontal

supports

D 1 ea

Upper

horizontal tube

STEP 1: Attach two horizontal supports (C) to the bottom side of

the top (G) using six medium hex screws (J). Tighten with hex

wrench (N). Include the safety bracket (O) in the middle between

horizontal support (C) and medium hex screw (J) as illustrated.

STEP 2: Assemble two wire shelves (B) to two side

frames (A) using eight long hex screws (I). Tighten with

hex wrench (N).

NOTE: When

assembling the

top make sure

safety bracket

(O) is facing

the back.

STEP 3: Attach the assembled top onto the side frames (A)

using four long hex screws (I). Tighten with hex wrench (N).

Back View:

NOTE: Correct orientation of the wire

shelves is the thinner wire on top.

STEP 4: Attach two middle

vertical tubes (E) to the

assembled unit using two short

hex screws (K). Tighten with hex

wrench (N).

Summary of content (2 pages)

PAGE 1
6764-10131 Modern Industrial Entryway Tower C 2 ea E 2 ea H 2 ea K 6 ea N 1 ea P 1 ea D 1 ea F 2 ea I 20 ea L 4 ea O 1 ea Q 1 ea Upper horizontal tube Side frames Horizontal posts Middle vertical tubes Horizontal supports A 2 ea Upper vertical tubes B 2 ea Long hex screws G 1 ea Wire shelves J 6 ea Top Medium hex screws STEP 1: Attach two horizontal supports (C) to the bottom side of the top (G) using six medium hex screws (J). Tighten with hex wrench (N).
PAGE 2
STEP 5: Attach two upper vertical tubes (F) to the assembled unit using two short hex screws (K). Tighten with hex wrench (N). STEP 9: To install the safety bracket, mark the spot on the wall with a pencil. For drywall installation: Take a nail-set, awl, or nail and with a hammer tap a “pilot hole” into the wall. DO NOT make the hole wider than the anchor. Place the anchor (Q) over the hole and firmly tap it in until it is flush with the wall. For stud installation: discard wall anchors.