Assembly Instructions

6822-167-B Clothes Closet ©2015 Whitmor, Inc.
B 4 ea
Horizontal frame tube
G 1 ea
Cover
C 4 ea
Horizontal Male frame tube
F 1 ea
Male clothes rod
D 6 ea
Vertical frame tube
Part Reference
A1
A2
B
C
D
E
F
G
F6947
F8101
F6954
F6955
F6956
F6957
F6958
F6959
Assembly
Time:
Less than
1 hour.
This product's intended use
is for storing clothes.
Tools Needed: No tools required.
STEP 1. To assemble the
lower frame, insert two
frame tubes (B) into one
corner support (A1). Insert
two male frame tubes (C)
into center support (A2)
where frame tubes
intersect. Place another
corner support (A1) onto
the end.
STEP 2. Insert six vertical frame
tubes (D) into lower frame. Do not
assemble the vertical frame tube
sections together yet. Unzip
zipper on cover (G) and carefully
fit holes in bottom of cover over
the vertical frame tubes. Slide
cover down and carefully lay the
cover back.
STEP 4. Complete assembly by
unfolding the vertical frame tubes
(D) and placing the two sections
together. Place assembled upper
section (assembled in step 3) onto
end of frame tubes.
STEP 5. Lift cover up over the
top of the frame, carefully fitting
the corners of the cover over the
top corners of the frame. Slide the
bottom of the cover downwards
evenly to the base of the frame.
E 1 ea
Clothes rod
A1 4 ea
Corner support
Note: All metal parts must be
inserted firmly and completely into
the plastic parts.
Note: Closet rods (E & F) are wider
in diameter than frame tubes (B & C)
and are inserted into the larger lower
center holes on (A1 & A2).
Note: Although your clothes closet
can be assembled by one person, it
is recommended that two people
install the cover.
STEP 3. To assemble top of
frame, insert two frame tubes (B)
and the clothes rod (E) into one
corner support (A1). Insert center
support (A2) onto the tubes. Insert
two male frame tubes (C) and the
male clothes rod (F) into center
support where frame tubes
intersect. Place another corner
support (A1) onto the end.
D
Note: For easier assembly, unzip
cover before installing.
D
D
G
G
8680 Swinnea Road • Suite 103 • Southaven, MS • 38671
MADE IN CHINA
NEED HELP? For help with assembly, or if you are missing a part,
please call Whitmor’s Customer Service Department, 1-888-944-8667
between 8 a.m. and 4:30 p.m. (Central Standard Time) Monday
through Friday. Or email: [e-mail]
Note: Make sure (E) is placed
through the stickered side of (A2)
first, then slide in (F) from opposite
side. This will help make sure the
parts fit snugly.
Rev.2 | 04.13.15 Printed in China
A2 2 ea
Center support
A1
A1
A2
B
B
C
C
A1
C
C
F
A1
A2
B
B
E